Fritsch ANALYSETTE 28 IMAGESIZER, Руководство по эксплуатации

Страница: 27 / 66

NOTICE!
During the flushing procedure, the measuring or
flushing liquid is pumped at pressure out of the
outlet hose. Ensure that the hose cannot slip out
of the outlet or collecting vessel, and that it is
placed below the outlet connector on the disper-
sion unit. Otherwise the measuring liquid cannot
drain completely out of the system.
6. The connection marked "Liquid In" (6) is used to fill the system.
Connect the hoses attached to the pressure controller to your
water connection (b) or a liquid storage container and to the
"Liquid In" connection (6) on your supply unit (a).
The pressure controller is permanently set at 0.8 bar.
NOTICE!
All hoses must be fastened securely to the con-
nections provided with a hose clamp. When
laying, ensure that no kinks occur.
7. The connections "To Cell" (7) and "From Cell" (8) are already con-
nected to the corresponding connections of the measuring cell
insertion at the factory. See Chapter
Ä
Chapter 8.1 ‘Replacing
hoses in wet dispersion units’ on page 53.
4.9 Preparation of the computer
Computers provided by Fritsch GmbH are already
equipped with the software you need and can be used
directly after the device has been connected.
System requirements:
– Intel Core i7 Quad Core processor or equivalent
– Minimum of 8 GB system memory
– Primary drive: minimum of 256 GB SSD
– Secondary drive: 1 TB HDD
– NVIDIA graphics card
– USB 3.0 connection
– 22" monitor with 1920 x 1080 pixels resolution or
better
Software:
– Windows 7 or higher
– Adobe PDF reader
Installation
- 27 -