8
9
C.- Final assembly
1. Push clutch assembly into cylinder (0211) with all parts greased.
2. Put one axial bearing disc (0209) onto wedge (0241). Next, place the axial bearing (0209) and the
other bearing disc onto the first bearing disc, making sure they are all concentric (alll well greased).
3. Slide the mechanical multiplier assembly into the cylinder (0211).The primari plate (0239) should
stop with the cylinder.
4. Place the O-Ring (0214) into the slots in the cylinder. Then put the 4 Belleville springs (0213) onto
secondary plate. Be sure the springs are put in as in the drawing.
5. Place the preset-tension spring (0006) into the center of the secondary plate.
6. Screw the threaded spindle (0216), with pushrod (0218-090, 0002-125,160,200) and O-Ring
(0005), into the cylinder until the end. Then back off so that set screw (0215) can tighten into one
of the slots on the spindle.
7. Check assembly by turning spindle sleeve until it reaches the top of the cylinder (0211). If it does,
everything is correct. If not, the spindle sleeve may be too tight. Loosen the threaded spindle until
head screw will go into the next slot. Then recheck.
8. Test spindle for pressure, using a “short stroke” pressure gage for correct reading.
