freightliner PX113064S T 2016, Руководство пользователя

Страница: 198 / 236

11.2 Press either the LIGHT TEST switch or
lamp check button to begin the pre-trip
light inspection. If equipped, groups of
lamps will cycle on and off in the following
sequence:
•
Group 1: Always ON: marker lamps,
clearance lamps, tail lamps, licence
plate lamp
•
Group 2: Low beam headlamps
•
Group 3: High beam headlamps and
stop lamps
•
Group 4: Backup lamps and daytime
running lamps
•
Group 5: Front and rear fog lamps
•
Group 6: Turn signals and utility
lamps
NOTE: LED accent lighting turns off when
the high beam headlamps turn on.
11.3 Walk around the truck and check that the
lamps are working properly.
11.4 Verify that all exterior lights and reflectors
are clean and intact.
11.5 The pretrip light inspection can be stopped
by:
•
releasing the parking brake;
•
pressing either the lamp check
button on the key fob or the LIGHT
TEST switch on the dash.
12. To check exterior lamps manually:
12.1 Turn the keyswitch to the ON or ACC ON
position.
12.2 Make certain the parking brake is set.
12.3 Activate the high-beam headlamps and
hazard warning lamps.
12.4 Exit the cab and check that all exterior
lamps and reflectors are clean and intact.
12.5 Check that the brake lamps, tail lamps,
headlamps, turn signals, marker lamps,
identification lamps, and clearance lamps
are working properly.
WARNING
Inspect and maintain seat belts. When any part of
a seat belt system needs replacement, the entire
seat belt must be replaced, both retractor and
buckle side. Any time a vehicle is involved in an
accident, and the seat belt system was in use,
the entire vehicle seat belt system must be
replaced before operating the vehicle. Do not
attempt to modify the seat belt system; doing so
could change the effectiveness of the system.
Failure to replace worn or damaged seat belts, or
making any modifications to the system, may
result in personal injury or death.
13. Inspect the seat belts and tether belts.
13.1 Check the web for fraying, cuts, extreme
dirt and dust, or for severe fading from
exposure to sunlight, especially near the
buckle latch plate and in the D-loop guide
area.
13.2 Check operation of the buckle, latch, web
retractor, and upper seat belt mount on
the door pillar. Check all visible
components for wear or damage.
13.3 Check the seat belt and tether belt
connection points and tighten any that are
loose.
14. Adjust the rearview and down view mirrors as
necessary.
15. Test the service brakes.
15.1 With the key ON and air system fully
charged, set the parking brake.
15.2 Put the vehicle in the lowest gear and
gently attempt to move it forward. The
vehicle should not move.
If the vehicle moves, the parking brakes
are not operating correctly and must be
repaired before the vehicle is operated.
16. Test the backup beep.
f611436 05/09/2022
LIGHT
TEST
Fig. 18.7, Pretrip Light Test Switch
Pre- and Post-Trip Inspections and Maintenance
18.7