FREEWAY Height Adjustable Shower Trolley with Liner 1500mm, Руководство пользователя

Страница: 13 / 28

999076 – Revision A P a g e | 13 of 28
4.4 Height Adjustment
The Shower Trolley includes a height adjustment function which can adjust the height
of the support frame from 860mm to 1185mm. This function allows the carer and
patient to select their most comfortable and preferable support frame height, while
operating the Trolley under normal use.
When operating the height adjustment system, keep hands and other body
parts away from the moving parts below the support frame, there is a
potential of crushing and entrapment if not careful.
To operate the Height Adjustment function, follow the guidance below:
A. Press down the upper foot lever with your foot (as shown in figure 17). This will
begin to increase the height of the support frame.
B. Once the lever has been fully operated, release the lever and it will raise back
to its original height.
C. Repeat Step A and B until the desired height of the support frame has been
reached.
D. When the Trolley is at its maximum height, it will be noticeable that the lever
operation no longer increases the height.
E. To lower the height, simply press your foot down on the lower foot lever (as shown in figure 18).
F. Hold your foot on this pedal until the desired height of the support frame has been reached.
G. When the Trolley is at its minimum height, it will be noticeable that the lever operation no longer decreases the height.
4.5 Side Rails
The Side Rails ensure the patient does not fall from the mattress support, the side rails
are also important as they hold the liner in place, which will allow water to accumulate
on the mattress support. The Shower Trolley includes two side rails which function
identically.
The Side rails include risk of finger trapping when operating. Use carefully.
The Side Rails must always be closed during transport.
The Side Rails must always be closed to accumulate water on the mattress support.
When the Side Rails closed, ensure they have been fitted correctly and cannot
become detached. Ensure the pin is fitted at all times.
To operate the Side Rails, follow the guidance below:
4.5.1
Closing the Side Rails
A. Pivot the Side Rail 180 degrees and slot the flange into the U-Bracket slot as shown.
(Figure 19 and 20). Ensure the Side Rail slots into both U-Brackets at either end.
B. Place the Pin through the slot to secure the rail. (Figure 21).
4.5.2 Opening the Side Rails
A. Remove the Pin from the slot to release the Side Rail. The Pin can be released as it is
attached to a chain.
B. Vertically raise the Side Rail, to lift the groove out of the U-Bracket. Ensure the Side
Rail is removed from both securing U-Brackets at either end of the Rail.
C. The Rail can now be pivoted around and be released gently to rest against the frame
as shown.
Figure 17
Figure 18
Figure 19
Figure 20
Figure 21