Franklin Q-link, Инструкция по установке, программированию, эксплуатации и обслуживанию

Страница: 75 / 125

75
PRIMARY-45: Reference Loss Delay
Anlg Ref Loss
45) Delay 1s Min: 0s
Max: 20s
Default: 1s
Low reading on sensor could be normal
condition for some period of time. Delay should
be set to prevent drive from tripping under
normal condition.
PID Control Selection: Standard ‐ PID output
decreases when F/B increases, Inverted ‐ PID
output increases when F/B increases. PID is
enabled when PID is selected in Primary ‐ 42.
Selection for PID Set ‐ point source: (0) ‐ Keypad,
(1) ‐ 1A input 0 ‐ 10V or 4 ‐ 20mA selected by DIP
switch, (2) 2A input 0 ‐ 10V available when 2A DIP
switch is set to input, (3) – Communication, (4)
3A input 4 ‐ 20mA.
PRIMARY-48: PID Feedback Source
PID Mode
50) Inverted Default: (0) 1A Input
0 - 1A Analog Input
1 - 2A Analog Input
2 - 3A Analog Input
PID Feedback source selection: (0) ‐ 1A mA or V
based on 1A DIP Sw position, (1) ‐ 2A V input
(available if 2A DIP Sw is set to Input), (2) 3A mA
input
PRIMARY-49: PID Feedback Unit
PID Feedback Unit
49) 0 - PSI
1 - GPM
2 - inWC
3 - CFM
4 - inHg
5 - Feet
6 - °F
7 - mBar
8 - Pa
9 - kPa
10 - Meters
11 - °C
12 - Custom
13 - %
Default: (0) PSI
Unit selection for feedback signal.
PRIMARY-50: PID Feedback Max
PID Feedback Max
53) Min: 0.0
Max: 6000.00
Default: 100.0 PSI
Sensor (Transducer) maximum rating. For 0 ‐
250PSi transducer set it to 250.0PSI. * Number of
decimals depends on selected Unit.
PRIMARY-52: PID Set-Point Value
PID Set-point Value
52) Min: 0.0
Max: [Primary-50] x 0.95
Default: Determined by
Primary-1
PID Set ‐ point (Desired pressure, temperature,
GPM, etc.) Maximum value is 5% less than
Sensor range for proper PID operation.
PRIMARY-55: PID P-Gain
PID P-Gain
55) 10% Min: 0%
Max: 999%
Default: 10%
P ‐ Gain determines PID control sensitivity.
Greater value provides more sensitivity.
PRIMARY-56: PID I-Gain
I-Gain
56) 1.0s Min: 0.1s
Max: 32.0s
Default: 1.0s
I ‐ time determines PID response time. Greater
value provides slower response.
PRIMARY-46: PID Mode Select
PID Mode
46) Inverse 0 - Direct
1 – Inverse
Default: Inverse
PRIMARY-47: PID Setpoint Source
PID Mode Select
47) 0 - Keypad
1 - 1A Analog Input
2 - 2A Analog Input
3 - Comms
4 - 3A Analog Input
Default: (0) Standard