Franklin Q-link, Инструкция по установке, программированию, эксплуатации и обслуживанию

Страница: 32 / 125

32
Description
Name Type Description Details
Relay Output
Terminal
O1 Terminal Default Selection: Fault/N.O.
Fault, Run and Proof of Run
relay ‐ SW Configurable
(1.25A @ 125VAC, Max
Switching Voltage 250VAC)
O2 Terminal Default Selection: Fault/N.O.
Wet Input
Terminals
V1 Terminal 1
Default Selection: Speed A/Active High
(V)
Shutdown / Permissive /
Fireman's Override / Limit
Switch / Speed A / Speed B
/ None ‐ SW configurable
(Default N.O.)
12 ‐ 240VAC/VDC, 5mA
maximum
V2 Terminal 1 Common 1
V3 Terminal 2
Wet Input 2 default: External
Trip/Active High (V)
V4 Terminal 2 Common 2
Cooling Fan Fan Connector Fan Power Supply
Cooling fan for VFD
(factory wired)
Dry Input
Terminals
D3 Terminal Dry Input 3 default: None
Shutdown / Permissive /
Fireman's Override / Limit
Switch / Speed A / Speed B
/ None ‐ SW configurable
(Default N.O.) 24VDC 3mA
maximum
D4 Terminal Dry Input 4 default: None
Analog I/O
3A Terminal Input (4–20mA)
Analog PID reference or
speed reference. Max Error
allowed is 1% of Full Scale
SG Terminal Signal Ground/Shield
Signal Ground is shared
between terminals D3/D4
and 3A
Relay Output 2
03 Terminal Default Selection: Fault/N.C.
Fault, Run and Status relay
‐ SW Configurable (1.25A
@ 125VAC, Max Switching
Voltage 250VAC)
04 Terminal Default Selection: Fault/COM
05 Terminal Default Selection: Fault/N.O.

Analog Input (1A, SG) - The Analog Input mode is user selectable (0-10V, 0-24V or 4-
20mA) based on status of DIP switches.

Configurable Analog Input/Output (2A, SG) - The Analog Input/Output mode is user
selectable (0-10V input, or output 0-10V or 4-20mA) via DIP switches. When configured
as an input it only accepts an 0-10VDC input signal
.
As an output, it provides a
programmable/variable voltage or current.

Analog Input 3A is a dedicated 4-20mA input

Wet Inputs (V1-V2, V3-V4) - Voltage Input accepts AC/DC voltages 12-240V± 10%,
maximum current draw is 5mA. Inputs can be interchanged between N.O. and N.C.
Default state is Active High when voltage is present (N.O.).

Dry Inputs (D1, D2, D3, D4 SG) - Four Dry inputs with maximum current limit of 3mA are
available. Inputs can be interchanged between N.O. and N.C. Default contact state is
NO.

Power Outputs –
o
(A+, A-) The Damper Power output will be activated as soon as an active run
command from the VFD is initialized and provides 24V DC at 0.5A maximum. If
a limit switch or a timer is used, the VFD will not output until the switch closes or
timer expires.
(24, SG) The Control Power will output 24VDC at 50mA maximum. The Control Output will be
activated whenever the VFD is powered up to provide controls to sensors