F3D3
Series
Service Manual Parts Replacement / Section 2.6
Questions? Call Franke Technical Support Group For Your Area. Copyright
2012 Franke, Inc. All rights reserved.
2.6 Drum Rotor/Motor Block Replacement
Continued
21) If word
Ready
is in display and ready lights are on in
basket graphic, position empty fry basket under hopper
and press against basket bumper switch to start fries
loading cycle.
22) If lane dispenses fries [if present] or if rotor turns
smoothly in an attempt to dispense fries, the motor, rotor
block and shaft are working properly.
23) Re-hang and secure rear service access panel and
return Dispenser to normal operating location
.
Replacement Kit Contents:
Key Quantity
Description:
8
1
Motor Rotor Block
7
1
Rotor Drive Shaft
6
4
M6x12 Hex Head Screw [Block Mount]
5
4
M5x45 SHCS Screw [For Motor]
4
1
Foam Tape Gasket [3M]
3
1
Rubber Shaft Seal [38 mm diameter]
[Photo 5] – From rear
Remove old rotor block and
shaft and discard.
[Photo 6] From rear
Insert new rotor/motor shaft in
contoured rotor block.
[Photo 7] From rear
Insert new contoured block &
shaft into mounting position.
[Photo 8] From unit front
Mount new block using four bolts
provided. Press seal over shaft
& tight against freezer wall.
Rev. 1 6/2012
Tools Required:
10 mm [3/8”]
&
11 mm [7/16”] socket or wrench
10 mm [3/8” ] flat blade screwdriver
Medium Phillips screwdriver
4 mm [5/32”] Allen Wrench
