F3D3
Series
Service Manual Parts Replacement / Section 2.6
Questions? Call Franke Technical Support Group For Your Area. Copyright
2012 Franke, Inc. All rights reserved.
2.6 Drum Rotor/Motor Block Replacement
[See
Kit Contents – See Page 2]
1)
Roll unit out to allow access to rear service panel.
2)
Disconnect power at outlet. [Pull plug.]
3)
Remove screws securing rear service access panel. Lift
panel up and off.
4)
Disconnect both motor harness power connections.
5)
Using a 4 mm [5/32”] Allen Wrench, remove and discard
the four motor mounting screws.
6)
Remove motor by pulling straight out. Motor rotor block
will remain in place.
7)
From front of unit - open freezer door and remove the
fries hopper to provide more work room.
8)
Using a flat blade screwdriver, pry off and discard the
existing rubber shaft seal.
9)
Using an 11 mm [7/16”] socket or box wrench, remove
and discard the four block mounting bolts.
10) From rear of unit - remove and discard the old rotor block
and shaft assembly.
11) Assemble new block and shaft assembly.
NOTE
: Motor
notched end of shaft goes in block first. [See Photo 6]
12) Insert rotor block with shaft in freezer wall cutout.
13) From front of unit - insert and tighten the four M6
mounting bolts using 10 mm socket. [
NOTE
: If needed,
have someone brace or hold the block from back of unit.]
14) If foam gasket is damaged, pull or scrape off old gasket
and replace with new one from Kit. Remove paper from
adhesive back, slide gasket over protruding block and
stick to unit back panel. Gasket should be snug against
contoured block. [See Kit Diagram on page 2]
15) Take new rubber shaft seal from kit and push over
flattened hopper/rotor side of shaft until it seats in slot
and is tight against rear of freezer compartment.
16) From rear of unit - install the Drum Rotor Motor using a 4
mm [5/32”] Allen Wrench and the four new bolts
provided. Ensure motor gear case drive shaft engages
rectangular slot in plastic Rotor Drive Shaft.
17) Reattach electric power leads to motor terminals: [Red to
positive, Black to negative]
18) Return fries hopper to operating position inside freezer.
19) Reconnect unit to power supply.
Test
for proper motor/shaft/rotor operation by:
20) Turning ON main power switch & pressing LANE-
POWER touch pad on front control overlay.
Continued…
[Photo 1] From rear
Disconnect both rotor motor
power leads.
[Photo 2] From rear
Remove the four motor mounting
screws.
[Photo 3] From unit front
Remove and discard the four
block mounting bolts.
[
Photo 4] From unit front
Cut or pry off old shaft gasket
and discard.
