F3D3
Series
Service Manual Parts Replacement / Section 2.14
Questions? Call Franke Technical Support Group For Your Area. Copyright
2012 Franke, Inc. All rights reserved.
2.14 Door-Open Sensor Replacement
[See Section 1.5 for Part Number]
1)
Roll the unit out to allow access to rear service panel.
2)
Disconnect power at outlet. [Pull plug.]
3)
Remove the screws securing rear service access panel.
Lift panel up and out.
4)
Disconnect Door-Open Sensor cable lead from the wiring
harness. [See Photo 1]
5)
Using the 4 mm [5/32”] Allen/hex wrench, remove the top
two [Door Open] motor mounting screws only.
6)
Remove the Door Open Sensor & Bracket from the
motor assembly. Slide the sensor bracket to the right,
clearing the sensor flag or fin.
7)
Use small Phillips screwdriver (and pliers, as needed) to
remove sensor from the bracket. There are two screws.
8)
Position new Door Open Sensor on the mounting bracket
and attach using the two screws just removed.
9)
Position new sensor and bracket over motor mounting
holes. Ensure actuating flag is spaced midway within
sensor slot.
10) Replace and tighten the two upper motor mounting
screws using the 4 mm [5/32”] Allen/hex wrench.
11) Reattach the new Door Open Sensor cable lead to the
wiring harness.
Test
the replacement Door-Open Sensor as follows:
12) Plug in unit power cord to power supply.
13) Turn on main power switch and press LANE-POWER
touch pad on control overlay.
14) If word:
Ready
is in display and ready lights are on in
basket graphic, position empty fry basket under hopper
and press against the basket bump-switch to initiate fry
loading cycle.
15) If Lane properly dispenses fries, replacement Door-Open
Sensor and dispensing assembly is working properly.
16) Re-hang and secure rear service access panel and
return Dispenser to normal operating position.
[Photo 1]
Disconnect sensor lead from
Main Wiring Harness.
[Photo 2]
Use 4 mm [5.32”] Allen/hex
wrench to remove upper [Basket
Lift] motor mounting screws.
[Photo 3]
Use Phillips screwdriver and
small pliers to remove sensor
from bracket.
Rev. 1 6/2012
Tools Required:
Small & Medium Phillips screwdrivers
Small pliers
4 mm [5/32”] Allen/Hex Wrench