Frama Matrix F4 / F6
19
3.2. Setting franking mark
If you have put the new cartridge properly into place, you can now
press
“Yes” on the display
.
The inkjet cassette will now be tested and calibrated. This process
might take a few seconds. During calibration, the display shown op-
posite will appear.
If the inkjet cassette being used was already in place in your Matrix
franking system, you can choose between recalibration and taking
over the existing calibration data. Recalibration can be necessary if
the initial calibration did not result in a satisfactory franking mark,
e.g. the printing head was too cold, etc.
After calibration, you will be asked to print a test franking mark. Pick
up an envelope or a folded A4 sheet of paper. We recommend that
you use a filled envelope.
Lay the envelope / paper to be franked on the manual feeder MF /
MFD or in the automatic feeder AF.
The envelope / paper, etc. will be franked with a test mark and eject-
ed to the left.
This is how the test mark looks like:
On the left hand side, you can see set-
ting X and on the right-hand side set-
ting Y. The setting valid at the time is
indicated by an arrow. The arrows
should point where the lines appear to be “straightest”.
If this is already the case, you only need to confirm the following X and Y displays by pressing
the ENTER key. Sometimes however, it is necessary for you to change the setting to optimize
the results. Simply carry out the additional instructions.