Fractal Audio Axe-Fx III, Руководство пользователя

Страница: 124 / 151

118
12 SETUP MENU
PARAMETER Description
PC Mapping PC Mapping determines whether incoming MIDI Program Change messages
load presets 1-for-1, or load other presets and scenes instead. With PC
Mapping turned OFF, presets are loaded 1:1 based on incoming MIDI bank
Select and Program Change messages. With custom PC Mapping enabled,
incoming Program Change messages are re-mapped according to the values in
the table on the Custom page of the MIDI/Remote menu (see below).
INITIAL VALUE:
External Control 1–16
These sixteen parameters specify the initial value to be used for each of the
16 External Controllers ( p. 106 ) when the Axe-Fx III is powered on. This value
persists until data is received from the MIDI controller. This is especially useful
when an external MIDI controller is absent. For example, if you normally use an
expression pedal to control the volume in your presets, a missing pedal might
make the preset get “stuck” in a muted position. Setting an initial value of 100%
for the External Controller mapped to that pedal would ensure that when the
pedal is not connected, the volume will stay at 100% instead of 0%. This setting
is only; for controllers with a MIDI CC# assignment. It does not apply to local or
FC pedals or switches.
MIDI/REMOTE: MAPPING PAGE
With Custom PC Mapping enabled (see above), incoming Program Change messages are re-mapped according to
the values in the table in this section.
PARAMETER Description
Map to Preset
Map to Scene
When PC Mapping (above) is turned “ON”, the parameters in this table specify
which preset and scene are loaded for each incoming MIDI PC message.
See p. 46 for additional info on PC Mapping.
MIDI/REMOTE: BYPASS PAGE
The Bypass page of the MIDI menu allows you to map MIDI CC messages—or connected pedals and switches— to
bypass or engage blocks. CC messages can be sent by a MIDI controller or computer connected to the Axe-Fx
III MIDI IN jack, or via the USB connection of the Axe-Fx III. Each of these settings is global. In every case, the
method for mapping a controller to one of these functions is the same:
1. Use the
NAV
knob to select the desired function.
2. Use the
VALUE
knob to assign a controller to the function:
ƒ
1—127 to assign a MIDI CC#.
ƒ
PEDAL 1 or PEDAL 2 to assign a pedal connected to the on-board expression jacks of the Axe-Fx III.
ƒ
FC__ PEDAL 1–4 to assign a pedal connected to the corresponding pedal jack of the designated FC controller.
ƒ
FC__ SW 1–4 to assign a switch connected to the corresponding switch jack of the designated FC controller.
ƒ
NONE to remove all assignments from the selected item.
MIDI/REMOTE: CHANNEL PAGE
The Channel page works exactly like the Bypass page except the entries are used to set the Channel of each
block instead of its bypass state. The value of the CC message sets the channel as follows:
0 = Channel A 1 = Channel B 2 = Channel C 3 = Channel D
The series continues, repeating A, B, C, D for values up to 127 (D).