Fracarro 3DG-2S2-2T, Руководство по эксплуатации

Страница: 16 / 44

16
English
For the enablement or otherwise of the output back panel, the wording “Output BP ON” or
“Output BP OFF” is shown.
By clicking with the mouse on one of the present modules, the screen below opens, which
shows further details about the status of the selected module:
Beginning from the top, the software release and the module serial number are shown.
Then certain parameters are shown about the signal level and quality to the inputs (BER, SNR),
offset which is the frequency correction performed by the control unit when the transponder is
locked and, finally, the name of the locked multiplexer.
For the output, indications are given about the use of the available band for each mux.
In detail: bitrate used and available in numeric form (MBps), relative peaks and graphic bar
showing the real time and memory of maximum peak bitrate used and available, again in
numeric and graphic format.
The sections for the 2 muxes show 2 “buttons” to reset the peak bitrate memory and the bitrate
overflow alarm signalled with a red dot.
Remember that, as described above, the dot indicates the overflow state if it is enabled, not the
status of the mux, which is shown in the control unit status page.
Click on the mouse to select one of the 2 inputs, and the following screen opens: