User’s Manual 0020D1.01
Image AnyPlace IA-200
3.1.1 OSD Navigation Buttons
These are the OSD navigation buttons on the IR remote.
•
The
On/Setup
(indicated as
Power
) button toggles the IA-200 between On and Setup modes
of operation (as described in
Operational Modes
).
•
The
Menu
button is used to invoke the OSD main menu.
•
The
Up/Down/Left/Right
arrow buttons are used to navigate the OSD.
•
The
Enter/Select
button is used to activate an OSD menu selection.
3.1.2 Video Source Selection Buttons
Direct (one-touch) input selection is possible using the following buttons:
•
The
RGB
button selects the VGA port as the active input.
•
The
DVI
button selects the DVI port as the active input.
•
The
Video
button selects the composite video port as the active input.
•
The
S-Video
button selects the S-Video port as the active input.
•
The
YPbPr
button selects component video as the active input.
•
The
HDMI
button selects HDMI as the active input.
•
The
SDI
button selects the SDI port as the active input
3.1.3 IA-200 Special Feature Selection Buttons
Additional buttons are available to directly access key video processing features and to cycle
through the available enhancements:
•
The
LUT
button cycles through pre-loaded, and user programmed input LUT (Look Up
Tables, which can be used to brighten or darken the appearance of incoming video
•
The
TRNR
button accesses the Temporal Recursive Noise Reduction feature, cycling
through the four available settings (Off, Low, Medium, and High).
•
The
CNR
button accesses the Codec Noise Reduction feature, cycling through the four
available settings (Off, Low, Medium, and High).
•
The
eWarp
button cycles through the available User defined Warp Maps (created by eWarp
Generator and stored in Index 1 through Index 8)
•
The
Split
button activates/deactivates a split-screen mode for direct comparison of the image
with and without noise reduction activated.
•
The
Test
cycles through a series of embedded Test Patterns which are instantly rendered at
the current output resolution
3.2 Operational
Modes
The IA-200 has two operational modes,
On
and
Setup
(
Stand-by
). These modes are selected by
a dedicated key on the IR remote. The IA-200 also enables selection using the On Mode using
the ASCII control protocol with RS-232, USB, or Ethernet.
Page 20 of 49
© Flexible Picture Systems
