FPI Dell-Point GF45, Инструкция для владельца и по установке

Страница: 5 / 28

Greenfi re GF45 BioEnergy Stove 5
INST
ALLA
TION
IMPORTANT: SAVE THESE INSTRUCTIONS
The GF45 Stove must be installed in accordance with these instructions.
Carefully read all the instructions in this manual fi rst. Consult the building
authority having jurisdiction to determine the need for a permit prior to
starting the installation.
NOTE: Failure to follow the instructions could cause a malfunction of the
heater which could result in death, serious bodily injury, and/or property
damage. Failure to follow these instructions may also void your fi re
insurance and/or warranty.
BEFORE YOU START
It is very important to ensure that the stove is installed in a safe manner.
Be aware of fi re prevention rules and laws in your area. All applicable
National and Local codes must be met and complied with.
We recommend that your pellet stove be installed by an authorized
dealer / installer.
The stove’s electrical connection is to a standard grounded wall socket.
Special care should be taken so the connection cable is not damaged
in any way.
It is strongly recommended that you install a smoke detector as well as
an ABC type extinguisher near the stove. A power surge bar is also highly
recommended to protect the electrical components.
If the stove is installed by an uncertifi ed installer, FPI will not be held
responsible for any faulty operation including poor performance of the
stove.
IMPORTANT SAFETY INFORMATION
Only use approved fuels in multi-fuel burning appliances. Failure to comply
with this may create a hazardous situation and will void all warranties.
Never attempt to re-start your stove until it has fully cooled down. Starting
your stove using a gel is only recommended during automatic ignition
failure.
Never use or store fl ammable products close to the stove while it’s in use,
or at any other time.
The Prime button is only used to prime the auger when Hopper is empty.
Do not use the manual feeding procedures to start-up your stove as
these will create smoke in your house.
Ensure that the ash pan door is securely closed at all times when the stove
is in use. Air pressure could ignite the gas accumulated in the burn-pot
creating an overdraft condition in the combustion chamber altering the
performance of the burn-pot.
The GF45 model will not feed fuel if the front door or hopper lid are not
fully closed and the fi rebox in a negative pressure situation. These are
safety functions of the appliance.
INSTALLATION
UNIT LOCATION
1. For optimum benefi t from your appliance, speak to your professional
for help with your location.
2. The location you choose for your appliance can be a factor in how
it will perform. Choose an interior location where the vent will not
be affected by any external interference, i.e. trees, bushes, walls or
fencing (refer to "Vent Termination Requirements" section). Make
sure, at the time of the installation, that there is the least possible
interference with the existing components of the house. Install a non
fl ammable covering when necessary. Place the stove according to
recommendations made on "Clearances" section or according to the
safety label fi xed on the stove.
3. You can use the wall behind the stove to pass the chimney system
or simply join the stove to an existing chimney or a metal chimney,
with the use of an approved liner.
4. Ensure that all clearances to combustibles are met as per the safety
label and the diagrams on "Clearances" section.
5. This appliance requires outside air. Make sure that the outside
air supply does not come from a garage, an attic or any restricted
non-ventilated space. Air must come from the outside of the house
directly into the back of the stove.
6. This stove is not approved to be installed into a bedroom under any
circumstances.
7. The fl ooring under the stove must be made of a non-combustible
material, i.e. cement, ceramics, etc, and must extend at least 6"
(152mm) all around the stove. Refer to the diagrams on "Clearances"
section.
WHAT IS INCLUDED WITH THE GF45
Qty Description
1 pc User Manual
1 pc AC Power Inlet
1 pc Measuring Cup
1 pc Pipe Adapter Gasket
(for Pressure Reducer Plate)
1 pc Pressure Reducer Plate 1-1/4"
1 pc Pressure Reducer Plate 1-5/8"
1 pc Ash Poker
1 pc 7ft. 6in. Extension Cord
1 pc Outside Air Kit
IMPORTANT:
Stove must be cold before any attempt to clean the glass is made. Do
not use detergent containing abrasives to clean the windows or any
other parts of the stove. Use only recommended products found at
your local hearth shop for this type of cleaning.
IMPORTANT:
When cleaning the stove, always remove ashes into a steel container
and place outside the residence. Use gloves to handle or to empty
the ash pan.
IMPORTANT:
Before servicing the electrical panel, make sure that all electrical
sources is turned off to the stove and the
power disconnected. Do
not forget to disconnect the battery, control board, fans and switches
as well.