FPI Dell-Point GF45, Инструкция для владельца и по установке

Страница: 20 / 28

Greenfi re GF45 BioEnergy Stove 20
MAINTENANCE
Diagram 17
Diagram 18
TOP
RING
Maintenance Of The Burn-pot
Step 1: Use a 9/16 wrench to unscrew the two nuts (Diagram 17). Then
to raise the ring, it may be necessary to insert a fl at screwdriver between
the outside of the burn-pot and the top ring (Diagram 18). If required,
use a rubber mallet to loosen.
Diagram 19
CYLINDER
BURN-POT
Step 4: Use a rod which has a diameter of 1/8" (3 mm) to clean the
jets of the inner burn-pot (Diagram 20). Be sure to install the burn-pot
cylinder the correct way up. Angled holes to the top, straight holes to
the bottom.
Diagram 20
INNER
BURN-POT
Step 2: Remove the cylinder from inside the burn-pot (Diagram 19).
Maintenance Of The
Ash-extraction System
Step 1: Refer to Diagram 15 to determine the condition of the three
stainless steel ash screws. Sugars released by corn or wheat can stick
to the ash screws resulting in poor movement and ash removal. Check
by removing the ash-extraction system or look inside the burn pot.
Diagram 16
Diagram 15
Step 2: Use a 9/16 wrench to unscrew the two nuts (Diagram 17). Then
to raise the ring, it may be necessary to insert a fl at screwdriver between
the outside of the burn-pot and the top ring (Diagram 18). If required, use
a rubber mallet to loosen.
Step 3: Refer to Diagram 16. It is advisable to support the ash extraction
system before you undo these 9/16" nuts as once they are removed, the
ash extraction system will become loose and drop down. The "lovejoy"
connection will now be loose. This is an important part that must not be
misplaced or forgotten when re-assembling. Once removed soak screws
in warm water to remove deposits stuck to them from burning corn or
wheat, and use a copper based lithium grease on the auger gears.
Step 3: If necessary, use a steel brush installed onto a drill to remove
minerals stuck to the interior wall of the cylinder.
MAINTENANCE