FPG IN 5C08, Руководство по эксплуатации продукта

Страница: 32 / 52

Part No.26107 Rev J August 2018
- 32 - Inline 5000 Series Cabinets
Refrigeration
cont.
REFRIGERATED CABINETS - SERVICING
Dixell Default
Settings
cont.
Label Name Range Default Setting
AFH Differential for temperat. alarm recovery (0,1 °C÷25,5°C) (1 °F÷45°F) 1
ALd Temperature alarm delay 0 ÷ 255 min 15
dAO Delay of temperature alarm at start up 0 ÷ 23h e 50’ 1.3
AP2 Probe for temperat. alarm of condenser nP; P1; P2; P3; P4 P4
AL2 Condenser for low temperat. alarm (-55 ÷ 150°C) (-67÷ 302°F) -40
AU2 Condenser for high temperat. alarm (-55 ÷ 150°C) (-67÷ 302°F) 110
AH2 Differ. for condenser temp. alar. recovery [0,1 °C ÷ 25,5°C] [1 °F ÷ 45°F] 5
Ad2 Condenser temperature alarm delay 0 ÷ 254 (min.) , 255=nU 15
dA2 Delay of cond. temper. alarm at start up 0.0 ÷ 23h 50’ 1,3
bLL Compressor OFF for condenser low temperature alarm n(0) - Y(1) n
AC2
Compressor OFF for condenser high temperature alarm
n(0) - Y(1) n
i1P Digital input polarity oP=opening; CL=closing cL
i1F Digital input configuration EAL, bAL, PAL, dor; dEF; Htr, AUS EAL
did Digital input alarm delay 0÷255min 5
Nps Number of activation of pressure switch 0 ÷15 15
odc Compress status when open door no; Fan; CPr; F_C no
rrd Regulation restart with door open alarm n – Y y
HES Differential for Energy Saving (-30°C÷ 30°C) (-54°F÷ 54°F) 0
Adr Serial address 0÷247 1
PbC Kind of probe Ptc; ntc ntc
onF on/off key enabling nu, oFF; ES nu
dP1 Room probe display -- --
dP2 Evaporator probe display -- --
dP3 Third probe display -- --
dP4 Fourth probe display -- --
rSE Set operating value actual set --
rEL Software release -- --
Ptb Map code -- --
XR40CX
Hot Key To program the controller from a Hot Key:
•
Turn OFF the instrument, and disconnect probe Pr4.
•
Insert a programmed Hot Key into the 5 PIN socket and then turn the
Controller ON.
•
The parameter list of the Hot Key is automatically downloaded into the
Controller memory, the doL will blink, followed a by a flashing End .
•
After 10 seconds the instrument will restart working with the new
parameters.
•
Remove the Hot Key, and reconnect probe Pr4.
NOTE the message Err is displayed if programming fails. In this case turn the
unit off and then on again, if you want to restart the download again, or remove
the Hot Key to abort the operation.
Continued on next page