Chapter 2 Installation Instructions
25
400M01 Series User Manual
Wake-Up On LAN: J15
Through the Wake-Up On LAN function, a wake event occurring from the net-
work can wake up the system. To utilize this function, please be sure an ATX 12V
power supply with a 5VSB line capable of delivering a current of at least 1A, and
a LAN adapter which supports this function. Then connect the header to the
relevant connector on the LAN adapter, set
“PowerOn by PCI Card” to enabled
in the
“Power Management Setup” section of the CMOS Setup. Save and exit,
then boot the operating system once to make sure this function takes effect.
Wake-Up On Internal Modem: J16
Through this function, the system which is in the suspend or soft-off status can
be waked up by a ring signal received form the internal modem. When this
function is used, be sure an internal modem card which supports this function
is used. Then connect the header to the relevant connector on the modem card,
set “Modem Ring Resume” to enabled in the “Power Management Setup” sec-
tion of the CMOS Setup. Save and exit, then boot the operating system once to
make sure this function takes effect.
J15
5VSB
GND
1
Signal for waking up
J16
5VSB
GND
1
Signal for waking up
400M01-FOXCONN-V1.0-HW-en-030304.p65
2004-3-18, 13:51
25
