Four winns 338 Vista, Руководство пользователя

Страница: 65 / 161

Section H
Page 1
348 Vista Owner’s Manual
08/01
2. Connect each of the black (negative) battery cable
leading to the engine block to the negative (-) bat-
tery terminal on each of the three batteries.
Figure H1: Triple Battery Location
B. Operation
Power to the engines and all 12 volt electrical equipment
is controlled at the battery selector panel. On the 348
Vista model, separate breakers are provided on the bat-
tery selector switch panel to protect the engine, wind-
lass, forward and aft bilge pump, battery charger, and
ship systems.
1. Battery Selector Switch
The battery selector switch positions for the 348 Vista is
as follows:
“OFF” - With the battery selector switches in the “OFF”
position and the “SHIPS SYSTEMS” circuit breaker in
the “off” position, all 12 volt power to the boat is shut off
except to the automatic bilge pumps. Always turn the
battery selector switch to the “OFF” position when the
boat is unattended for an extended period.
NOTICE
Twelve volt power to the cabin panel is supplied
by the “SHIPS SYSTEMS” circuit breaker on the
battery selector panel. This must be turned on
to operate any 12 volt accessories on the cabin
panel. The bilge pumps receive power from the
ships system battery and remain on at all time
regardless of battery selector or ship systems
switch position.
H - 1 GENERAL
All electrical equipment on the Four Winns Vista® mod-
els operates on either 12 volts DC or 120 volts (220 volts
on 50 Hertz models) AC electrical power. A triple battery
system along with dockside power (including battery
charger) is standard on the 348 Vista. Batteries are lo-
cated in the engine compartment.
DO NOT tamper with any electrical connection,
panel or harness, or attempt installation of any
electrical equipment unless thoroughly familiar
with the systems and experienced in making
such installations.
Circuit breakers are installed on the battery switch to pro-
tect various system components. The SHIP SYSTEMS
breaker supplies power to all DC electrical components
except the aft and forward bilge pumps, ignition, and in-
strumentation. Additional breakers are located in the
cabin circuit breaker panel. The circuit breakers and fuses
are labeled for amperage and use.
H - 2 DUAL ENGINE - TRIPLE BATTERY SYSTEM
Two battery selector switches are installed on dual en-
gine, triple battery installations. This allows DC power to
be used from any of the three batteries. Refer to the
schematics in the back of the manual.
A. Installation
Connect each of the red (positive) battery cables lead-
ing from the battery selector switch to the positive
(+) terminal on each of the three batteries. Refer to
Figure H1.
NOTICE
Be sure all three cables are installed on the posi-
tive (+) battery terminals.
ELECTRICAL SYSTEMS
Battery Trays