Four winns 338 Vista, Руководство пользователя

Страница: 54 / 161

Section E
Page 12
348 Vista Owner’s Manual
08/01
ing in the lens of the unit.
When cleaning the LCD protective lens, use a chamois
and nonabrasive, mild cleaner. Do not wipe while dirt or
grease is on the lens. Be careful to avoid scratching the
lens. Refer to the manufacturer’s literature included in
the owner’s packet for additional information.
General Description: Depthsounder Faria
1. The depth finder will read to 199ft. or the correspond-
ing number of meters or fathoms. If the reading is less
than 19.9 ft, meters or fathoms, 1/10
th
increments will
be displayed. If the reading is more than 19.9ft, all read-
ings will be in whole numbers.
2. The depth finder has an audible and LCD displayed
depth alarm with adjustable shallow and deep limits and
a depth below keel offset feature. These settings once
made are stored in memory and will remain even if the
battery is disconnected.
Operation Instructions: Depthsounder Faria
1. Power on. The depth sounder will activate auto-
matically when the power to it is initially turned on. You
do not have to press the combination “ON / OFF MODE”
keypad. The LCD will illuminate showing the depth and
will also show the type of units selected, feet (FT), meters
(M), or fathoms (F). To turn the depth sounder off, press
and hold the “ON / OFF MODE” keypad for 4 seconds.
Pressing the “ON / OFF MODE” keypad again will reac-
tivate the unit.
NOTE: The instrument is designed to have the internal
LED lighting remain on as long as power is supplied
even if the unit is turned “off” at the keypad.
2. Depth alarm. Shallow mode: Pressing the “ON /
OFF MODE” keypad again displays the “SH” shallow
depth alarm setting. This is the shallowest water that
will activate the alarm. Press and hold the up or down
arrow keypads to adjust the reading to the desired depth.
Deep mode: Pressing the “ON / OFF MODE” keypad
again displays the “DP” deep depth alarm setting. This
is the deepest water that will activate the alarm. Press
and hold the up or down arrow keypads to adjust the
reading to the desired depth. When the shallow depth
setting is read by the depth sounder, the “SH” will flash
on the LCD and the audible alarm will sound rapidly.
When the deep depth setting is read by the depth
sounder, the “DP” will flash on the LCD and the audible
Return to
Normal
Operation
w/ Updated
Depth Readout
positive (+) number to set the unit for depth from the
waterline.
The available settings are +10 to -10 feet. After your
selection is made, the unit will return to normal opera-
tion after 5 seconds. The “KO” icon should now be vis-
ible as shown in Figure E18.
Figure E18: Keel Offset Icon
Figure E19 depicts a scenario where the KEEL OFF-
SET has been set to -2 feet. The last drawing shows
the return to normal operation with the updated depth
readout.
Figure E19: Keel Offset Scenario
NOTICE
DO NOT depend solely upon the depth sounder
for water depth. It is important to have navigational
charts of the waters in which you are operating.
Do not rely on depth sounder to avoid submerged
objects. Depth sounders provide a relative indica-
tion of water depth only.
6. Maintenance of HDR 600 Depthsounder
If the unit comes into contact with salt spray, simply
wipe the affected surfaces with a cloth dampened in fresh
water. DO NOT USE a chemical glass cleaner on
the lens . Chemicals in the solution may cause crack-