Four winns 338 Vista, Руководство пользователя

Страница: 112 / 161

Section O
Page 2
348 Vista Owner’s Manual
08/01
NOTICE
Two people are required if removal or installa-
tion becomes necessary. Care must be exer-
cised so the radar arch does not become dam-
aged. Use a protective covering to prevent dam-
age to arch.
NOTICE
In the event the canvas requires some mainte-
nance or repair, remove the bimini camper can-
vas from the bow assembly. Unzip the bow
sleeves, unsnap all snaps and straps, and re-
move the canvas.
Figure O1: Shock Cords
O - 4 USE OF WEATHER COVERS AND CARBON
MONOXIDE
When an engine is running, a natural vacuum may exist
with the right wind and sea conditions to allow exhaust
gases (which includes carbon monoxide) to seap into
the boat. When the camper or side curtains are installed,
this compounds the possibility of this occurring and in-
hibits natural ventilation. For more information, refer to
Section B-2 - Carbon Monoxide in this manual.
The carbon monoxide in exhaust fumes can be hazard-
ous. It is important for you and your passengers to be
aware of the potential safety hazard created by exhaust
fumes. Familiarize yourself with the symptoms of indi-
viduals overcome by carbon monoxide, and most impor-
tantly, ways you can protect yourself and your guests.
A window is provided forward of the bimini camper of the
top. Side and aft curtains are removable and have win-
dow covers which roll up or are removed to expose the
screens. The camper will square off and attach to the
stern. Installation information is also included in Figures
O2 & O3 at the end of this section.
The bimini camper top is factory installed, therefore,
minimal adjustment is necessary. To utilize the bimini
camper top:
1. Remove the canvas boot from the top.
2. Extend the forward connector bow forward and at-
tach the straps to the strap eyes mounted on the
windshield. Some adjustment may be necessary.
3. Extend secondary bow aft and attach the straps to
the strap eyes mounted on the stern of the deck.
Some adjustment may be necessary.
4. Zip in forward clear section and snap to windshield.
Starting at the walk-thru windshield may prove to be
easiest. Windshield snaps can be adjusted to match
snaps in canvas.
5. Slide each end of the clear forward section into their
respective slide tracks located along each side of
the radar arch. Use of a silicone spray may ease
their insertion.
6. Zip in side and aft curtains. Snap canvas to deck
beginning at forward edge. Readjust bows if neces-
sary.
7. Attach the aft curtain’s shock cords to knobs along
the stern as shown in Figure O1. Be sure canvas is
centered on stern.
NOTICE
Canvas should be snug. If too taut or extremely
tight, canvas could tear or pull at seams.
NOTICE
The bimini camper has been designed and is
intended to remain installed in the boat. Four
Winns does not recommend the bimini camper
assembly be removed from the boat unless ab-
solutely necessary.