Four winns 338 Vista, Руководство пользователя

Страница: 124 / 161

Section R
Page 2
348 Vista Owner’s Manual
08/01
13. Remove all oxidation from exterior hardware and ap-
ply a light film of moisture - displacing lubricant.
C. Prior to Winter Storage
1. Remove as many cushions as possible. Remove
storage lids or hatches. Open as many locker doors,
as possible. Open the refrigerator door. Leave these
areas open to improve ventilation.
2. Spray the weather covers and the boat upholstery
with Lysol Spray Disinfectant™. Enclosed areas
such as the refrigerator, shower basin, storage locker
areas, etc. should also be sprayed with Lysol Disin-
fectant™.
3. Place small dishes of rodent poison such as D-Con™
in a number of areas around the boat. Be sure dishes
are placed near the head and the engines, as ro-
dents will destroy upholstery, water intake and dis-
charge hoses.
4. If the boat will be in outside storage, properly sup-
port a storage cover and secure it over the boat.
DO NOT secure the cover tightly to the boat. This
does not allow adequate ventilation and can lead to
dry rot. DO NOT store the boat in a damp storage
enclosure. Excessive dampness can cause electri-
cal problems, corrosion, and dry rot.
Placing an electric or fuel burning heating unit
in the bilge of the boat during cold weather could
cause fire or explosion and is not recommended.
5. DO NOT use the bimini top or camper top as a win-
ter storage cover. The life of these covers may be
significantly shortened if exposed to harsh weather
elements for long periods.
R - 2 ENGINE FLUSH OUT
The optional engine flush out should be used to clean
the engine of unwanted salt, mud, sludge, etc. which
may have accumulated in the engine cooling system.
Before winterizing the engine, flush out the system for at
least five minutes.
Make sure that no section of flush hoses are in
contact with moving or hot engine parts or abra-
sive surfaces such as screw threads, sharp
edges, etc., which could damage the hoses.
Damage to the hoses could cause leaks and
possible flooding of the engine compartment.
Periodically check hoses for abrasions.
NOTICE
The flush out kit should only be used with the
boat in the water and the engine OFF.
To flush out the engine, follow the instructions below.
1. Do not run engine during flushing procedure.
2. Remove cap from coupling and attach swivel con-
nector.
3. Attach water supply hose to swivel connector.
4. Turn water on and allow water to flush the engine
and exhaust manifold for five to ten minutes.
5. Turn water off. Disconnect hose; replace and tighten
cap securely.
Reinstall cap onto coupler after flushing. Floo-
ding of the engine compartment will occur if the
cap is not installed and tightened.