Fortinet AP400 Series, Руководство по установке

Страница: 44 / 102

Install the AP433e 30
2.
Verify that the AP is unlocked using the locking key on the unlock mechanism (on the
same side as the Ethernet ports).
3.
Press the AP433e against the T-bar at a slight angle and then rotate into place, as indi-
cated in
Figure 10 on page 29 . You should hear it snap in place.
4.
For each antenna, loosen the knurled ring at the base of the antenna, orient the antenna
and then retighten the ring.
5.
Connect one end of the PoE Ethernet cable to the AP’s Ethernet port (see Figure 11 on
page 30 ).
Figure 11: Ports and Unlock Mechanism for the AP433e
Mount AP433e Above a Suspended Ceiling (Plenum)
Use the optional T-bar box hanger mounting kit to mount the AP433e above suspended ceiling
T-rails (see
Figure 13 on page 32 ). The installation attaches the T-bar box hanger to the ceil-
ing rails and then the AP433e attaches to the T-bar box hanger. Note that an AP433e mounted
above the ceiling has about 2-3 dBm less RF coverage than an AP433e mounted under the
ceiling.
The AP433e with the metal enclosure exposed meets the requirements for fire resistance and
low smoke-generating characteristics required by Section 300-22(C) of the National Electrical
Code (NEC) for installation in a building’s environmental air space.
You may need to modify thicker tiles to support this installation.
Be sure to connect the Ethernet cable to the Ethernet port; the cable can mistakenly be plugged into the
Console port. If you do this. the AP won’t power up.
RESET
USB
CONSOLE
G1
Console
port Ethernet
port USB
port
00260
When installed in air-handling spaces, such as above a suspended ceiling, power the AP433e only with
a PoE, not a power supply.