ENGLIS
outside temperature or travel. Set throttle to Fast position for
normal operation
Stopping the engine
Turn the engine off after use and remove ignition key. Run engine for a
few minutes before stopping to help dry off any moisture on the engine.
1. Remove the ignition key. Removing the key will reduce the
possibility of unauthorized starting of the engine while equipment
is not in use. Keep the key in a safe place. The engine cannot start
without the ignition key.
2. Wipe any moisture away from the controls on the engine.
Snow removal
Allow unit and engine to adjust to the outdoor temperature before
clearing snow.
DO NOT overload unit capacity by attempting to clear snow at a too fast
rate. Use slow speed to clear deep or hard packed snow.
Auger clutch should be engaged before drive clutch when throwing
snow.
1. Select Speed Control position and direction.
2. Engage auger clutch firstly – right handle lever.
3. Engage drive clutch secondly– left handle lever.
4. Switch on the heat handle could warm both right and left handle
bar.
Tips for Operation
1. Snow is best removed as soon as possible after snow fall.
2. To clear an area, run unit in an overlapping series of paths. For
large areas, start in the middle and throw snow to each side, so
snow is not cleared more than once.
3. Always direct snow away from area to be cleared and with direction
of the wind.
Traveling
1. To travel from one work area to another:
2. Set Throttle to Slow or Part-Throttle position.
3. Engage drive clutch without engaging auger drive clutch.
18
