ENGLIS
Allow unit and engine to adjust to the outdoor temperature before
clearing snow. Before shut-off, run the attachment a few minutes to
prevent impeller freeze-up.
Try out each control without the engine running to see how it works and
what it does.
Manual Start
1. Turn discharge chute straight ahead.
2. Make sure that the drive clutch and auger clutch levers are fully
disengaged.
3. Push Primer Bulb 2 or 3 times for cold engine. When temperature
is below -15° F (-26° C) additional priming may be needed.
4. If engine is cold, apply choke to full choke position. Detailed
please see engine manual for detailed instructions. A warm engine
requires less choking than a cold engine.
5. Set throttle to proper starting position
6. Insert key into ignition switch on engine and push into "Run"
position. DO NOT twist key after it is inserted.
7. Grasp starter handle and pull rope out slowly until it pulls harder.
Let rope rewind slowly.
8. Pull rope with a rapid continuous full arm stroke. Let rope rewind
slowly.
9. Repeat steps 7 and 8 until engine starts.
10. Adjust choke as needed.
11. Set throttle to Part Throttle or Slow position for adaptation to
outside temperature or travel. Set throttle to Fast position for
normal operation.
Electric Start (120v)
Warning!
The electric starter is equipped with a grounded three-
wire power cord and plug, and is designed to operate on 120 volt AC
household current. It must be used with a properly grounded three-
prong receptacle at all times.
1. Connect extension cord to starter
2. Plug extension cord into 120V 3-wire, grounded outlet.
3. Turn discharge chute straight ahead
4. Make sure that the drive clutch and auger clutch levers are fully
disengaged.
5. Push Primer Bulb 2 or 3 times for cold engine. When temperature
is below -15° F (-26° C) additional priming may be needed.
6. If engine is cold, apply choke to full choke position. For details,
please see engine manual for detailed instructions. A warm engine
requires less choking than a cold engine.
7. Set throttle to proper starting position
8. Insert key into ignition switch on engine and push into "Run"
position. DO NOT twist key after it is inserted.
9. Press electric starter button on engine until engine starts. DO NOT
press the button more than 15 seconds per minute as overheating
and damage can happen.
10. Adjust choke as needed.
11. Disconnect power cord from outlet.
12. Set throttle to Part Throttle or Slow position for adaptation to
17
