ENGLIS
2. Reassemble new skid shoes with the four carriage bolts (two on
each side) and hex flange nuts.
To change the scraper:
1. Remove the carriage bolts and hex nuts which attach it to the
auger housing.
2. Reassemble new scraper, making sure heads of carriage bolts are
inside of housing. Tighten securely.
Check and adjust the drive clutch cable (Fig. 27 & 28)
The drive clutch cable is adjusted at the factory. During normal use,
the cable can become stretched and must be checked and adjusted as
follows.
1. To check for correct adjustment, disconnect the “Z” fitting from the
lever.
2. Move the lever forward until the lever is contacting the plastic
bumper.
3. The control cable is correctly adjusted if the center of the “Z” fitting
is aligned with the hole in the lever and there in no droop in the
cable.
4. If not correct, remove the plastic cable cap on the bottom of cable,
change the “Z” fitting on the steel plate with holes until the correct
adjustment.
5. Reconnect the “Z” fitting to the drive clutch lever.
Check and adjust the auger clutch cable (Fig. 29)
The auger clutch cable is adjusted at the factory. During normal use,
the cable can become stretched and must be checked and adjusted as
follows.
1. Measure the length of the auger clutch cable spring with the clutch
lever disengaged.
2. Measure the length of the auger clutch cable spring with the clutch
lever engaged.
3. Calculate the spring extension, the recommended range is 1/2” –
9/16” (12.7 – 14.3mm).
4. If outside of the range, loosen jam nut on cable, clockwise or
counterclockwise the bolt to increase or decrease the spring
21
