FOR-A HVS-350HS, Руководство по эксплуатации, Страница: 71 / 266

57
8-6. Simultaneous Transitions of BKGD, KEY1 and KEY2
Two or three background, KEY1 and KEY2 buses can be performed transitions at the same time
in the M/E bus section. The way to perform simultaneous transitions on three buses is as
follows:
(1) Set the transition type for the background , KEY1 and KEY2 to MIX or WIPE. Select a pattern
using the menu if set to WIPE. (See the note below.)
(2) Set the transition rate or direction, if necessary.
(3) Press BKGD, KEY1 and KEY2 simultaneously to light up the buttons.
(4) Press AUTO, or move the fader lever to perform the simultaneous transition.
Limitations of Use of WIPE or DVE Patterns
 Up to two channels of WIPE patterns (No. 0-99) are available at the same time. KEY1
and KEY2, however, cannot use WIPE patterns simultaneously.
 Up to two channels of DVE patterns (No.100-162) are available, but only one channel of
2Ch-DVE patterns (No.170-181) can be used at the same time.
 If two channels of WIPE or DVE have been already assigned to any buses, the settings
cannot be made and the WIPE button will not light up when the button is pressed. In this
case, cancel another WIPE or DVE setting, and then press the WIPE button again.

When performing pattern transitions with a DVE pattern (No.100-162) for KEY1 or
KEY2, all 2D DVE menu settings are disabled.
See section 8-7. "Pattern (WIPE/DVE) Transitions." for details about transition settings.
AUTO CUT
DVE
DVE
FADER LIMIT
DIRECTION
P IN P
1
P IN P
2
KEY 1
KEY 2
REV
BKGD
NOR/REV
KEY1
NEXT TRANSITION
TRANSITION TYPE
PATTERN
KEY2
WIPE MIX
TRANSITION
RATE