FOR-A HVS-350HS, Руководство по эксплуатации, Страница: 119 / 266

105
14-1. CG WIPE Operation Example 1

Ex. 1: CG WIPE using STILL1 and KEY1
In this example, save a CG (V + K) to the clip memory, set STILL1 and STILL KEY to KEY1
signals, display KEY1 on the screen and play the CG through KEY1. Then set CG WIPE to ON,
and perform a background transition. Change IN/OUT points, transition rate and delay values to
adjust the CG WIPE sequence, if needed.
<Setting up KEY>
(1) Press MENU above the keypad, then press STILL to display the [STILL] (1/6) menu. Set
STILL1 to CLIP.
(2) Press the page down button to go to PAGE 6 in the [STILL] menu. Turn F3 to set
KEYOUT to STIL1 (STILL1).
(3) Quickly press KEY1 twice in the BUS SELECT section to display the [KEY1 SETUP]
menu.
(4) Turn F1 to select INS/SRC, then press F1 or the page down button to display the [KEY1-
INS/SRC] menu.
(5) Set TYPE to BUS, INSERT to STL1 (FILL) and SOURCE to STKY (KEY).
KEY1 : TYPE :INSERT :SOURCE :INVERT : 1/3
INS/SRC : =
BUS : = STL1 : = STKY : =OFF :
<Setting up BKGD>
(1) Press BKGD in the M/E transition section.
(2) Press WIPE to set the BKGD transition type to WIPE.
(3) Press PATTERN in the M/E transition section to display the [WIPE PATTERN] menu,
then press F1 to enter a desired pattern number on the keypad. Then press ENTER to
confirm the selection. (Note that MIX, FAM and NAM can also be used for CG WIPE.)
(4) Modify the selected pattern suitable for your CG WIPE sequence.
<Setting up CG WIPE>
(1) Display the [WIPE MODIFY] menu by pressing MENU then WIPE.
(2) Turn F1 to select CG WIPE. Press F1 or the page down button to display the [WIPE
BG-CG WIPE] menu.
(3) Set ENABLE to ON on PAGE 1.
Select STILL under CG. (See
A
in Fig. 1, p. 104)
Set the CG playback time in frames under DUR. (See
B
in Fig. 1)
WIPE BG :ENABLE : CG : : DUR : 1/4
CG WIPE : =
ON : = STILL : := 30 :
(4) Press the page down button to go to PAGE 3 and select KEY1 under SELECT. (See
C
in
Fig. 1)
(5) Set delay time in frames under DELAY, which indicates the duration from the start of CG
playback (IN point) to the time when KEY1 is displayed on the screen. (See
D
in Fig. 1)
WIPE BG :SELECT : DELAY : : 3/4
CG WIPE : =
KEY1 : = 0 : :
(6) Go to PAGE 4. Set the delay time in frames under DELAY, which indicates the duration
from the start of CG playback to the transition start time. (See
E
in Fig. 1)
Set the background transition time under RATE. (See
F
in Fig. 1)
WIPE BG : DELAY : RATE :FDRLINK: : 4/4
CG WIPE : =
0 : = 30 : =ON : :