FOCO INSERTO 13, Руководство пользователя

Страница: 94 / 290

22
EN
Stand-by mode
This mode allows the automatic shutdown of the insert once it reaches the temperature set on SET.
When this happens, the insert will wait a few minutes (factory setting), after which will turn off
automatically if the temperature of the room in the meantime has always maintained above the set.
Once turned off as a result of this condition, the insert will automatically turn on only when the
ambient temperature will drop to 2 °C below the set temperature in the oven (example: SET=24 °C
and ambient temperature = 21 °C).
If the insert is turned off for the sleep-mode, although there is an ignition programmed this will be
ignored and the heater will turn back on only to lower the temperature as explained above.
The sleep timer is instead always respected if the insert is in STAND-BY and is turned off manually by
pressing the OFF button; doing so the insert will shut down permanently rekindling not more, less
than expected from the ignition weekly programming.
Enabling stand-by mode
Press the SET (3) to access the menu and with the button (5) reach the
M E N U 0 5
(
S T A N ‐ B Y
M O D E
). Then press SET (3) to access it; STAND-BY function is set by default to OFF.
To activate this feature, press (1), on the display you will see “
S T A N ‐ B Y M O D E O N
” . Press SET (3)
to confi rm and then OFF (4) to leave. The STAND-BY mode is now active.
1
2
3
3
1
1
1
2
2
2
3
3
External thermostat
The insert has the possibility to interface with an external thermostat to control the ignition and
switch off of the insert according to the room temperature. The thermostat must be of open / closed
type with a clean contact.
If the thermostat carries voltage to the card causing faults, the warranty will expire.
To confi gure the thermostat, simply remove the jumper on the Therm clamp (see the tab on page 30)
and connect the room thermostat
OPERATION BY A SPECIALIZED TECHNICIAN
Once switched on, the insert will remain in operation until the temperature set in the thermostat is
reached.
When the contact is opened the insert will remain in modulation and the display will show ECO
THERM for 5 minutes, after which it will go to Stand-by ECO + OFF.
At the moment of a new heat request in the room (and therefore re-closing), the insert will remain in
ECO ATT mode for 10 minutes. If during this time the contact remains closed, the insert will switch
on.
NOTE:
At the moment when the insert will be switched off manually or by programming, it will no
longer be connected by the thermostat.