FOCO INSERTO 13, Руководство пользователя

Страница: 89 / 290

17
EN
Alarm signals
In the event of a working defect, the system informs the user about the type of failure occurred.
The following table summarises the alarms, kind of problem and possible solution:
Display Kind of problem Solution
ALAR 1 BLACK OUT
There is no power supply
As soon as the power supply is back, the Insert
starts a cooling cycle: it will be necessary to restart
it manually
ALAR 2
PROBE
EXHAUST
The smokes sensor is broken or
not connected to the pcb
Contact an Authorized Assistance Center
ALAR 3
HOT
EXHAUST
Smokes temperature too high
Switch off the Insert, allow it to cool down and
perform ordinary cleaning. If the problem persists,
contact an Authorized Assistance Center for
cleaning the Insert and the fl ue
ALAR 4
FAN
FAILURE
Smokes extractor blocked or
broken
Contact an Authorized Assistance Center
ALAR 5
NO
LIGHTIN
The Insert cannot start up
This is the fi rst light-up Fill in the tank with pellets
Start up again
ALAR 6
NO
PELLET
The pellet Insert switched off
while working
Fill in the tank with pellets
ALAR 7
SAFETY
THERMAL
The water temperature exceeds
100°C.
Clean the inert and the fl ue. Reset the thermost
manually. If the problem persists, contact an
Authorized Assistance Center
ALAR 8
FAILURE
DEPRESS
Obstructed fl ue
Clean the fl ue or check there are no obstructed
grids near the smokes exhaust
SERV
The Insert has worked for
1200 hours. Supplementary
maintenance required
Contact an Authorized Assistance Center
Regular checks should be carried out by the user, who should only contact the Authorized
Assistance Center if no solution is found.