FOCO INSERTO 13, Руководство пользователя

Страница: 80 / 290

8
EN
Operating area
How to place the Insert
For proper functioning and a good temperature
distribution, the Insert shoul be positioned in a
location where it is able to take in the air necessary
for combustion of the pellet (about 40 m
3
/h
must be available), as laid down in the standard
governing the installation and in accordance with
local national standards.
The volume of the room must not be less than
30 m
3
.
The air must come in through permanent openings
made in walls (in proximity to the Insert) which
give onto the outside, with a minimum cross-
section area of 100 cm
2
.
These openings must be made in such a way that
it is not possible for then to be obstructed in any
way. Alternatively, the air can be taken from rooms
adjacent to the one which needs ventilating, as
long as they are provided with an air intake from
the outside, and are not used as bedrooms or
bathrooms, and provided there is no fi re risk such
as there is for example in garages, woodsheds,
and storerooms, with particular reference to what
is laid down in current standards.
It is not permissible to install the
Insert in bedrooms, bathrooms, or
in a room where another heating
appliance is installed (Insert, Insert etc.)
which does not have its own independent
air intake. Locating the Insert in a room with
an explosive atmosphere is prohibited.
The fl oor of the room where the Insert is
to be installed must be strong enough to
take its weight. Keep a minimum distance
of 50 mm between the covering and the
fi replace insert. If walls are fl ammable,
maintain a minimum distance of (A) 450
mm , rear of (B) 300 mm, side of (C) 400
mm, front of (D) 1000 mm and from fl oor
of (E) 450 mm. If the room contains objects
which are believed to be particularly
delicate, such as drapes, sofas and other
furniture, their distance from the Insert
should be considerably increased. The two
side walls of the chimney insert must be
accessible for maintenance by authorized
technicians.
Connection to the external air intake
It is essential that at least as much air must be
able to fl ow into the room where the Insert is
installed as is required for proper combustion in
the appliance and for the ventilation of the room.
This can be effected by means of permanent
openings in the walls of the room to be ventilated,
which give onto the outside, or by single or
collective ventilation ducts.
For this purpose, on the external wall near the
Insert, a hole must be made with a minimum free
cross-section of 100 cm
2
. (equivalent to a round
hole of 10 cm diameter or a square hole 10x10
cm) protected by a grille on the inside and the
outside.
The air intake must also: communicate directly
with the room where the Insert is installed be
protected by a grille, metal mesh or suitable
guard, as long as this does not reduce the area
below the minimum.
Be positioned in such a way as to be impossible
to obstruct.
B
300
mm
A
450
mm
D
1000
mm
E
450
mm
min.
100
cm 2
C
400
mm