Operating Manual EMGZ309._.EIP
23
7.2
Display Value Selection State
The EMGZ309 can display either a tension value or the amplifier output that is an
electrical unit corresponding to the measured tension.
A) For tension display following unit can be selected: N, kN, lb, g, kg
B) The amplifier output can be displayed in 0…10VDC, 0…20mA or 4…20mA
7.3
Displaying of Overload, Over and Underflow
In the Operation State the EMGZ309 amplifier will indicate limit violations on the
display depending on the chosen unit:
A) If a tension has been chosen, the reading on the display at overload will be:
B) If the display was set to show the amplifier output, following messages will be
displayed:
At overflow:
or
At underflow:
or
Note
An overflow messages is caused by the maximum output value 10V or 20mA
being overshot. An underflow message is caused by the minimum value 0V or
4mA being undershot. The parameter [F@OutMax] can influence the overflow
messages. If the actual tension value overflows the value entered in [F@OutMax],
an error message will be displayed.
Overload
1200.0 N
Out>Max
20.00 mA
Out<Min
0.00 mA
Out>Max
10.00V
Out<Min
0.00 V
