2
INTRODUCTION
Model PN-36 series us a wood-burning fireplace intended
and approved for installation in either residential homes or
buildings of standard construction.
This model is not for use in mobile homes.
This fireplace system requires the utilization of an
FMI 10”
double-wall, snap-lock flue pipe system.
GLASS DOORS
are standard with this fireplace and come
in different styles (see parts list on last page).
BE SURE TO CHECK WITH YOUR LOCAL BUILD-
ING CODES FOR AREA REQUIREMENTS BEFORE
INSTALLING THIS FIREPLACE.
The model’s serial number and any other specific rating in-
formation may be found on the unit in the
UL RATING
PLATE
located at the interior of the fireplace’s opening (
See
figure 1)
BEFORE YOU BEGIN:
Before beginning the installation of your fireplace; read these
instructions through completely.
This FMI fireplace and its approved components are safe
when installed according to this installation manual and oper-
ated as recommended by FMI. Unless your use FMI approved
components tested for this fireplace,
YOU MAY CAUSE A
FIRE HAZARD!
The FMI warranty will be voided by, and FMI disclaims any
responsibility for the following actions:
A) Modification of the fireplace or any of the components
manufactured by FMI unless otherwise permitted by FMI.
B) The use of a fireplace insert or any other component part
not approved by FMI in combination with an FMI fireplace.
C) Installation and/or operation in a manner other than in-
structed in this manual.
D) The burning of any other fuel not tested or approved by
FMI in this wood-burning fireplace.
PROPER INSTALLATION is the most important step in en-
suring a safe and continuous operation of this fireplace.
Although grounding may not be required by code in your
area, it must be electrically grounded in accordance with local
codes or, in the absence of local codes, with the
National
Electrical Code, ANSI/NFPA 70-1987.
This fireplace is intended for installation in accordance with
the
National Fire Protection Association
Standard for
Chimneys, Fireplaces, Vents, and Solid-Fuel Burning Fire-
places,
NFPA 211,
and in accordance with codes such as the
BOCA
Basic/National Code,
the
Standard Mechanical
Code,
and the
Uniform Building Code.
NOTE:
Installation and repair should be done by a qualified
installer. The fireplace and chimney system should be in-
spected and cleaned before use and periodically thereafter
especially during heating season to ensure a safe operating
system.
THIS FIREPLACE IS NOT INTENDED TO BE USED
AS A PRIMARY SOURCE OF HEAT.
SELECTING LOCATION
To determine the safest and most efficient location for your
fireplace, you must take into consideration the following
guidelines:
1. The location must allow for all the proper clearances (see
section on clearances).
2. Consider a location where the heat output would not be
affected by drafts, air conditioning ducts, windows or doors.
3. A location that avoids the cutting of joists or roof rafters
will make installation easier.
4. If an outside air kit is to be installed, accessibility to outside
combustion air must be considered. This can also be achieved
through a vented crawl space in some cases, for more details
refer to section on outside air kit installation.
The typical installation for a peninsula is a
projected instal-
lation
, which allows you to extend the fireplace any distance
into the room. A projection may be ideal for a new addition on
an existing, finished wall.
Figure 2
This wood burning fireplace complies with
UL 127
as a
FACTORY BUILT FIREPLACE and is listed and tested
by
Underwriters Laboratories Inc.
