11
FINISHING YOUR FIREPLACE
CABINET DOOR INSTALLATION
Glass doors have been provided with this fireplace. A set
includes the front glass panel assembly. They come in differ-
ent styles, check with your local distributor for availability
and options.
To install doors and front panel, simply insert top door pin(s)
up into hole(s) on top frame, and insert bottom pin (D) into
hole(S) on bottom frame until door is fully seated.
No alignments or adjustments are necessary (see fig. 29).
FIREPLACE FACING
Any non-combustible material may be used for facing (glass,
title, brick, etc.) as long as the proper clearances are adhered
to (refer to section on clearances) and the fireplace opening
are not blocked or obstructed in any way (see fig. 30).
Use only heat resistant, non-combustible mortar or adhesive
when securing facing material to the front of the fireplace.
When placing facing at the upper edge of the effective open-
ing of the fireplace, provide an “L” shaped piece of metal ex-
tending the full width of the opening.
Secure with sheet metal screws at a distance high enough
from the edge as to not interfere with the operation of doors.
This assures that the facing material, in time, should not block
the opening if it where to lose cohesion.
FLASHING MANTLES:
Mantles, combustible or non-combustible, may be constructed
(see below) as long as the proper clearances are observed.
Refer to page 2 for clearances.
Figure 30
Figure 29
Figure
30
D1018