10
FLASHING INSTALLATION
Determine the flashing to be used with the roof-opening
chart. Slide flashing over pipe until base is flat against roof.
Replace as many shingles as needed to cover exposed area and
flashing base. Secure in position by nailing through shingles.
DO NOT NAIL THROUGH FLASHING CONE.
STORM COLLAR INSTALLATION
Place storm collar over pipe and slide down until snug
against the open edge of the flashing (see
figure 26
).
Apply
waterproof caulking
to all seams and notched around
storm collar and also at base around shingles.
TERMINATIONS
The fireplace system must be terminated with the listed
round top or chase terminations. Refer to the installation in-
structions supplied with the termination.
The terminations approved for this fireplace are
RTL-10D
,
which can be used for flashing or chase and
ETL-10D
for
chase style termination only. Figure
27
shows an RTL-10D
round top termination.
CAUTION:
DO NOT SEAL OPENINGS ON THE ROOF-
TOP FLASHING. FOLLOW THE INSTALLATION IN-
STRUCTIONS PROVIDED WITH THE TERMINATION
BEING USED.
CHASE INSTALLATIONS
Instructions for chase installations are included with the
chase style termination chosen although it is worthy to men-
tion here that in a multiple chase installation, provide adequate
distance between termination’s or smoke spillage from one
termination to another may occur. We suggest they be sepa-
rated at least 30” center to center and stacked at a vertical
height difference of 18” vertically from one termination to the
other (see figure
28
).
Figure 27
Figure 25
Figure 26
Figure 28
