FM4040 Installation Instructions
CI 202 Iss 1 26-11-02 Page 9 of 20
When all programming is complete Key in 48 to exit engineer mode
ADDING WIRELESS DEVICES
When installing the system you may find it easier to label each detector with its
zone number and learn them into the panel before installation. Once
programmed into the panel's memory, the information will not be lost even when
power is removed from the panel.
01
PROGRAM DEVICES ONTO ZONE 1
Select program number 01. The numbered LED's will indicate how many
detectors are already on that zone. eg. if LED's 1, 2 and 3 are lit then there are 3
devices on that zone.
To delete all detectors from that zone press Part set & O keys together.
To add a detector to a zone, briefly short out the learn jumper on the detector and
ensure that the learn pins are not left permanently shorted. (The PIR sends a
learn by pressing the walk test button)
The panel will emit 2 short blips to indicate that it has learnt the detector and the
new total of devices on that zone will be displayed on the numeric LED's.
Press the Full Set key to exit.
02
PROGRAM DEVICES ONTO
ZONE 2
03
PROGRAM DEVICES ONTO
ZONE 3
04
PROGRAM DEVICES ONTO
ZONE 4
05
PROGRAM DEVICES ONTO
ZONE 5
06
PROGRAM DEVICES ONTO
ZONE 6
07
PROGRAM DEVICES ONTO
ZONE 7
08
PROGRAM DEVICES ONTO
ZONE 8
09
ADD PANIC BUTTONS
To delete all Panic button already on the system press Part & 0 keys together.
To add a new device press the panic button. The panel will emit 2 short blips to
indicate that it has read the panic button and LED 1 will indicate that one PA has
been programmed in.
