FM4040 Installation Instructions
CI 202 Iss 1 26-11-02 Page 8 of 20
Once the Sounders and dialler have been connected and the installation
completed a full test with remote signalling should be carried out.
HOW TO MAKE A PROGRAMMING CHANGE
The following sequence shows how to change a program option:
1.
Enter the engineers code 4 6 7 9
The Alarm led will flash slowly to indicate that you are in the program mode.
2.
Key in the two digit program number.
(The zone led's indicate which option is set.)
3.
Key in the option required
(The zone led's indicate your choice)
4.
Press the Full Set key to exit that program step.
5.
When finished with programming key in 48 to exit engineer mode.
ERROR CORRECTION VIA THE PART SET KEY
If you accidentally enter an engineer program number and change an option
value, you can undo the change by pressing the Part Set key before exiting the
program step via the Full Set key.
EXAMPLE:
To make supervision active.
Key in 4 6 7 9
To enter engineer program mode
Key in 40 To select supervision
Key in 1
To make supervisory active.
Zone 1 LED indicates your choice
Press the Full Set button to exit the program step.
Note:
The Full set button must be pressed to complete each program step.
Until the Full Set button is pressed any key press just changes your choice of
option.
