Flyer Goroc 3, Перевод оригинального руководства пользователя, Страница: 187 / 252

34
1. There are markings on the seat post
which show how far it can be pulled
out of the frame. Never pull the seat
post beyond the maximum length
marking. Otherwise the seat post may
buckle or break. If you require a
longer seat post to reach the correct
sitting position, talk to your FLYER
specialist retailer. Never ride with a
seat post extended further than the
maximum marker as this could result
in serious falls and injury.
2. Children and persons who are not
confident cyclists should be able to
touch the ground with the tips of both
feet. Otherwise, when stopping they
run the risk of falling and suffering
serious injury.
Telescoping seat post
FLYER Uproc models can be supplied ex works
with a height-adjustable seat
post. This allows the seat
height to be lowered or ad-
justed rapidly and safely in
difficult terrain, for example
before big drops.
The height of the seat can
lowered by operating the
switch on the handlebars
while pushing down on the seat. If you want to
return to your normal riding position, simply oper-
ate the handlebar switch and briefly remove any
load pushing down on the seat. The support then
resets the seat to its usual height.
It is essential that you read the part man-
ufacturer’s operating manual when set-
ting up and operating suspension seat
posts and telescopic seat posts.
FLYER MT171 seat post
If your FLYER E-MTB is fitted with a MT171
adjustable seat post, please note the following
ST OP
1. Inappropriately installed wheels may
shift while you are driving or detach
from the vehicle. This may damage
the vehicle and lead to severe or
life-threatening injuries to the driver. It
is therefore important to take note of
the following instructions: Ensure that
the axle, the dropouts and quick re -
lease mechanisms are free of dirt.
Take care that they are correctly at-
tached at all times. Contact your
FLYER specialist retailer and have
your vehicle checked when you are
not sure.
2. Check that all quick release fasten-
ers and quick release axles are firmly
attached, even if your FLYER only
remained unsupervised for a short
time. You may only start driving when
all quick release fasteners are firmly
closed.
12.2 Setting up the seating position
The seat, handlebars and stem must be adjusted
to your body mass and the desired sitting positon
in order to use your FLYER safely and comfort-
ably.
Only allow FLYER specialists to work on
your handlebars and stem. These are
components which are crucial for your
safety, so incorrect work and tools in this
area of the bicycle could lead to serious
falls.
The seat and stem can be attached with
screw connections or quick releases.
Always secure screw connections with
the correct torque,see “Technical Data”.
Seat height
In order to transfer the pedal force effectively to
the pedals, you must set your seat to the appro-
priate height.
Find the ideal position by sitting on the FLYER
and placing the heel of your foot onto the pedal in
its lowest position.
Now the bottom leg should be stretched. If this
is not the case, dismount, adjust the seat in the
required direction and try again.
Ensure that the quick release fastener is com-
pletely closed after the adjustment process.