Fluke 5540A, Руководство оператора

Страница: 76 / 78

5560A/5550A/5540A
Operators Manual
70
Error 6007 result Calculated corrector out of tolerance
Error 7001 result Frequency must be > 0.0 Hz
Error 7002 result Function does not permit a frequency below [VALUE]
Error 7003 result Cannot specify more than one frequency
Error 7004 result Cannot specify more than two magnitudes
Error 7005 result Units are required for dual output mode
Error 7006 result Not applicable
Error 7007 result Cannot set Duty Cycle in this configuration
Error 7008 result Cannot set Offset in this configuration
Error 7009 result Range Lock disabled in this configuration
Error 7010 result Compensation not available for this function
Error 7011 result Cannot enable compensation in this configuration
Error 7012 result Harmonic not available for this function
Error 7013 result Fundamental not available for this function
Error 7014 result Setting Range not available for this function
Error 7015 result Cannot change polarity for this function
Error 7016 result This value cannot be slewed
Error 7017 result Cannot change Phase for this function
Error 7018 result Validation of requested attributes failed
Error 7019 result Offset range not found
Error 7020 result Read only mode for calibration control
Error 7021 result Must be in read only mode to execute this command
Error 7022 result Cannot enter watts by itself
Error 7023 result Value not available
Error 7024 result Harmonic not available for non-sine waveforms
Error 7025 result TC offset can only be set while in TC Measurement function
Error 7026 result Temperature Scale can only be set while sourcing or measuring temperature
Error 7027 result RTD type can only be set while in RTD Source function
Error 7028 result TC type can only be set while in TC Source/Measure function
Error 7029 result Coupled command queue limit exceeded
Error 7500 result Cannot have magnitude above [VALUE] in function [FUNCTION]
Error 7501 result Cannot have magnitude below [VALUE] in function [FUNCTION]
Error 7502 result No appropriate range found in function
Error 7503 result Magnitude exceeds boundaries of selected range
Error 7504 result Incorrect units for selected function [FUNCTION]
Error 7505 result Invalid second range selected for function [FUNCTION]
Error 7506 result Current post/range mismatch for function [FUNCTION]
Error 7507 result Cannot have frequency above [VALUE]
Error 7508 result Cannot combine greater than [VALUE] with frequency above [VALUE]
Error 7509 result Cannot have both Duty Cycle and DC Offset
Error 7510 result Duty Cycle must be between 1 and 99
Error 7511 result Duty Cycle is only available with Square Wave