Fluke Calibration RUSKA 7615, Руководство пользователя

Страница: 44 / 64

RUSKA 7615
Users Manual
5-4
ANSI/IEEE 488.2-1987 Command Summary
*CLS Clear Status
*ESE? Event Status Enable Query
*ESE <number> Event Status Enable
*ESR? Event Status Register
*IDN? Identification
*OPC? Operation Complete Query (Returns 1)
*OPC Operation Complete
*RST Reset
*SRE? Service Request Enable Query
*SRE <number> Service Request Enable
*STB? Status Byte Query
*TST? Self-Test Query
*WAI Wait (No operation)
SCPI Command Summary
The current value associated with a SCPI command may be read by appending a question
mark to the command. For example CALC:LIM:UPP? will return the current upper
pressure limit.
MEASure
[:PRESsure]?
returns current pressure reading
:PRESsure2? return pump pressure
:POSITION? returns pump position (%)
CALCulate
:LIMit
:LOWer
<number> get/set low pressure limit
:SLEW <number> get/set slew rate limit
:UPPer <number> get/set high pressure limit
:VENT <number> get/set auto-vent limit
:TARE
:VALue
<number> get/set tare value
:STATe ON/OFF set tare using current pressure
CALibration
[:PRESsure]
:DATA
:POINts? read
number of calibration constants
:VALue<n>? read label, calibration constant
:CALibration
:POINts? read
number of calibration points
:VALue<n>? read nominal calibration point
:VALue<n> <number> perform calibration point
:ZERO performs zero calibration
:VALUE <number> sets vacuum value
:INITiate enter zero calibration mode
:INITiate? returns status for cal, press, temp,
ref
:RUN start zero calibration
:STOP abort zero calibration
:PRESsure2
:DATA <number>,<number> sets C0, C1 for pump pressure
:VALue <number> sets first calibration point
:VALue2 <number> sets second calibration point
:POSition
:DATA <number>, <number> sets C0, C1 position
:DATA? reads C0, C1
:VALue <number> sets second calibration point
:MODE? calibration edit enabled?
:MODE ON¦OFF¦1¦0 enable calibration edit
(Cal. button required)
DISP
:ENABle ON¦OFF¦1¦0 turns front panel display on/off
:TEXT <string> displays message on front panel
:BGRaph <number> sets bar graph maximum
OUTPut
:STATe
ON¦OFF¦1¦0 off=MEASure, on=CONTrol
:STATe? returns 0=Measure or 1=Control