Fluke Calibration RUSKA 7615, Руководство пользователя

Страница: 27 / 64

Installation
Tutorial
3
3-5
3. Press Units (the F3 key). This will display the Menu/Setup/Units screen. The list of
available units will be displayed with the current units highlighted.
kPa mmHg 0
º
cmH20
4º
C user1 feet
bar
CmHg 0
º
inH20
4 º
C user2 meters
inHg
0
º
inH20 20
º
C Pa knots
kg/cm2 inHg 60
i
nH20 25
º
C %FS km/hr
Define
PSI
4. Use the arrow keys located on the right of the display to move the highlight bar.
5. When the unit desired is highlighted, press the ENTER key on the far right side of the
front panel under the numeric keypad. The display will return to the Menu/Setup
screen with the current units.
6. Press PREV to return to the MENU screen.
7. Press PREV again to return to the Main Menu.
The second part of this tutorial illustrates how to set up the Calibrator to generate
pressure. The system must be fully charged with fluid, the air supply connected, and the
test port connected to a closed volume full of fluid.
8.
From the Main Menu use the numeric keypad to enter the set-point pressure. The
pressure is entered in the units set in the previous illustration. As you enter the
pressure, each digit will be displayed in the numeric scratchpad (the highlighted box
in the middle of the display). If you make a mistake, press the CLEAR key (under the
numeric keypad) and the numeric scratchpad will be cleared.
9. When the entry is correct, press the ENTER key. The scratchpad will be cleared and
the value will appear to the left of the scratchpad.
10. Now that the starting pressure is entered we can now enter Control mode. Press
CONTROL (the F2 key). The highlight will move from MEASURE to CONTROL
and the message “Press Enter to Confirm” will appear above the function key
definitions. Notice that the upper left corner still shows MEASURE. The Calibrator
stays in Measure mode until the change is confirmed.
MEASURE
27.16
PSI
Set Point 50.00
Measure Control Vent Step
C
Step
D
Press ENTER to Confirm
Menu
ABSOLUTE
11. Press ENTER to confirm the mode change. The upper left corner will change to
CONTROL and the pressure will start moving towards the set-point.
38.27
PSI
Set Point 50.00
Difference -11.73
Measure Control
Control
Vent Step
C
Step
D
Press ENTER to Confirm
Menu
ABSOLUTE