Fluke Calibration 1586A Super-DAQ, Руководство по калибровке, Страница: 22 / 54

1586A
Calibration Manual
14
General Maintenance
The subsequent sections describe how to maintain the Product.
Clean the Product
To clean the Product, wipe the instrument with a cloth that is lightly dampened
with water or mild detergent. Do not use aromatic hydrocarbons, chlorinated
solvents, or methanol based fluids.

Caution
To prevent possible damage to the Product, do not use
solvents or abrasive cleansers.

Caution
For safe operation and maintenance of the Product:
•
Have an approved technician repair the Product.
•
Do not allow water to get inside the Product.
If the Product Does Not Turn On
To help solve problems encountered when turning on the Product:
1. Make sure that the power switch is in the “On” position.
2. Make sure that the mains power cord is firmly plugged into the power module
on the rear of the Product.
3. Make sure the power source that the Product is plugged into is energized.
4. Make sure that the line power fuse is good. See
Replace the Line Power
Fuse .
If these steps do not solve the problem, then contact Fluke Calibration. See
Contact Fluke Calibration .
Replace the Line Power Fuse
The Product has a fuse that protects from overcurrent. Each voltage selection
requires a specific fuse. See Table 2 for the correct fuse for each of the four line-
voltage selections. This fuse is located on the rear panel.

Warning
To prevent possible electrical shock, fire, or personal injury,
use only specified replacement parts.
Table 2. Fuses
Voltage Selector Fuse Fluke Part Number
100 V

0.25 A, 250 V (slow blow) 166306
120 V

0.25 A, 250 V (slow blow) 166306
220 V

0.160 A, 250 V (slow blow) 4394437
240 V

0.160 A, 250 V (slow blow) 4394437