6.7.6. Saving and restoring the unit settings
IMPORTANT
Note that transceiver software configuration (*.CONF) files are
not interchangeable with RACER configuration setup
(*.FMCONF) files.
The
LOAD OR RESTORE SETTINGS
window contains controls that allow
you to:
• Save the unit's existing software configuration as a configuration
(*.CONF) file.
• Upload and apply a saved configuration file to the current unit.
TIP
Saved configuration files can be copied and distributed
for use on more than one Fluidmesh unit of the same
type, simplifying the configuration of other deployed
units.
Saved configuration files can also be used for
configuration backup. This can greatly speed up re-
deployment if a damaged unit must be replaced with a
unit of the same type.
To download the unit's existing configuration settings to your computer, do
the following steps:
1.
Click the
-configuration settings
link under
MANAGEMENT
SETTINGS
in the left-hand settings menu.
• The
LOAD OR RESTORE SETTINGS
dialog will be shown
).
Figure 75. Configurator GUI (LOAD OR RESTORE
SETTINGS dialog)
2.
Download the unit's configuration (*.CONF) file to your computer
by clicking the
Save
button and following the software prompts.
Fluidmesh 4200 FIBER
© Fluidmesh Networks LLC
Page 146 of 180
