6.2
I am unable to log-in into the Web-based inter-
face
If you are unable to log-in into the Web-based interface, check your user
name and password settings.
The user name cannot be changed by the user and corresponds to:
admin
The password can be changed so make sure you are using the right pass-
word. The default password is:
admin
If you forgot the password, check Section 6.3 to fix the problem.
6.3
I forgot the administrator password
If you forgot the password and need to access the Web-based interface,
you must physically access the unit, open the enclosure in a weather-safe
situation and reset to the factory default settings. Please refer to the in-
structions of Section 3.1.4 for FM1100 and Section 3.2.5 for FM2200 units.
6.4
With FM1100 in bridge mode I am unable to get
any video from the cameras or from the Remote
Ethernet Device
Is the Ethernet cable used to connect the cameras or the video server to
the FM1100 a crossover cable?
A standard Ethernet cable cannot be used to connect an IP camera or
a video server to a FM1100. Make sure that you are using an appropriate
crossover Ethernet cable rather than a standard Ethernet cable. You should
connect the FM1100 unit to the PoE Injector using a crossover cable and
your PC to the PoE injector with a patch straight cable. Using two patch
cables or two crossover cables will not work.
6.5
With FM1100 in bridge mode I get no Link or the
Link LED is always red or I am getting a weak
Wireless link (below 60% signal strength)
To improve your link strength, please check the following:
44
