DataView™ LI55 Level Controller
Quick Start
7
| P a g e
Connections
All connections are made by attaching wires onto removable screw
terminal connectors located at the rear of the DataView.
Copper wire with 60°C or 60/75°C insulation should be used for all line
voltage connections, observing all safety regulations. Electrical wiring
should be performed in accordance with all applicable national, state,
and local codes to prevent damage to the meter and ensure personnel
safety.
The connectors’ label shows the function of each of the connections,
such as POWER, RELAY, SIGNAL, etc. The RJ-45 M-LINK connection
is intended for Flowline expansion modules, cables, or meters ONLY.
Any other use of the DataView's RJ-45 connection may damage the
DataView and any equipment connected thereto. The different types of
connections are explained on the following pages.
DO NOT connect any equipment other than Flowline’s expansion
modules, cables, or meters to the RJ45 M-LINK connector. Otherwise
damage will occur to the equipment and the meter.
DataView Connections Labeled
