Flo TRACER 1000 3G LTT1-3G, Руководство по эксплуатации

Страница: 8 / 25

(877) 356-5463 | (p) 330-331-7331 | (f) 330-331-7172 | www.FLO-CORP.com | © 2018 FLO-CORP | REVA 0918
7
(877) 356-5463 | (p) 330-331-7331 | (f) 330-331-7172 | www.FLO-CORP.com | © 2018 FLO-CORP | REVA 0918
8
IFACE WIDTH
Set water reading (level 2) offset in the event of a merged echo. A merged echo
will occur if the interface is too thin to produce a separate echo. The offset is
measured from the end of the merged echo backwards. Default 150mm (0.5ft)
Note: This is an advanced setting and should not be adjusted without expert
knowledge
Adjustable
IFACE SIZE
Sets the echo size (in signal voltage) to dictate whether an echo is from the
Interface or Level. If the echo is larger than the value the unit will assume no
Interface is present and will set Level 1 reading to be the same as Level 2 reading.
If the echo is smaller it will assume there is only an Interface layer measurable and
will set Level 2 to end of probe measurement. Default 2.34
Note: This is an advanced setting and should not be adjusted without expert
knowledge
0-2.49
COMMISSIONING
PARAMETER INSTRUCTION
1. SET INTERFACE MODE If the application is NOT an interface application, disable interface mode.
2. SET HIGH AND LOW
LEVEL
High and Low level distances can be programmed manually or you can run
Autoset. Autoset can be used to program the High or Low level based on the
material level which is touching the probe when the function is run.
3. SET TRACKING
SPEEDS
Tracking speeds can be set to Fast, Medium, Slow and Custom (measured in
Displayed Units per hour)
4. SELECT DIELECTRIC
Choose closest Dielectric range of Upper material Level from the pre-set list.
Select lower value if unsure. <2 will be appropriate for most Interface applications.
5. RUN DIGITIZE
Confirm displayed distance is either material level (for Interface applications
it must be the Upper Layer) or end of probe if vessel is empty.
Ensure the value is not greater than the distance to the material level.
See ‘Digitize Function’ for additional critical information.
6. SET DK
COMPENSATION
Program Dielectric value of Upper Material Layer in Interface Menu
7. ADD DAMPING
Increasing Damping value if a smoother response trend is required. This
value is automatically set by the Tracking speed.
8. RUN UNIT Press RUN several times to commence unit operation