FLIR Quasar Gen II Series CM-6212 H1-I, Руководство пользователя и инструкция по установке, Страница: 72 / 146

September 6, 2017 66
Configuration and Operation
CM-6212 H1-I User and Installation Guide
Trigger Action
The Administrator can specify various alarm actions to take when an alarm is triggered. The following
options are available:
·
Enable alarm output – Select this checkbox to enable alarm relay output. The checkbox is not
selected by default.
·
Send message by FTP – Select the checkbox send an alarm message by FTP when an alarm is
triggered.
·
Upload image by FTP – Select this box to assign an FTP site and configure the parameters
shown. When an alarm is triggered, event images are uploaded to the designated FTP site.
Note:
Images can be sent by FTP only when MJPEG is selected as the video stream from the Video
Format screens in the Streaming tab.
Follow these steps:
·
From the FTP address drop-down list, select one of the two FTP addresses to use.
·
From the Pre-trigger buffer and Post-trigger buffer drop-down lists, select the number of
frames for the buffer from 1-20 frames.
Upload Image by FTP
·
Select the Continue image upload checkbox to upload an image by FTP for a defined period
of time or while the trigger is active. Select one of the following options:
·
To specify the length of time for the upload, select Upload for and enter the number of
seconds in the text box.
·
To upload while the trigger is active, select Upload while the trigger is active .
In the Image Frequency text box, from the drop-down list select the number of frames
per seconds from 1-15 for the upload.