FLIR Quasar Gen II Series CM-6212 H1-I, Руководство пользователя и инструкция по установке, Страница: 29 / 146

23 September 6, 2017
Installation
CM-6212 H1-I User and Installation Guide
·
For installing on a 4S recessed electrical box:
a. Have a qualified installer (check your local electrical codes) rough-in the 4S recessed
electrical box and run the wires and power (if not PoE) through the wall/conduits to the box
location.
b. Ensure that the box is sufficiently sturdy (attach to the wall stud, ceiling joist, or reinforced
surface as needed) to securely hold the weight of the camera.
·
For bracket, pole and pendant installations:
a. Feed the system cable through the mounting accessory.
Note:
The power cable is not required if using PoE.
Tip:
Even if you are not using alarm inputs and audio input/output at the time of installation,
you may want to consider pre-wiring these connections for future use.
Use shims for shoring up mounts on uneven surfaces.
b. Thread the wires through the base plate and screw it to the pre-drilled wall, ceiling,
CM Series Recessed Mount, CM Series Corner Mount, or 4S electrical box. Check that
the installation is not flimsy, will not wobble, and is flush with the mounting surface.
c. Plug the Cat 5 cable into the camera’s Ethernet port and, if needed, plug the power
terminal block into the power terminals.
d. If applicable, wire the Alarm In, Alarm Out, Audio In, and Audio Out terminal blocks to
external devices. See
Cable Connectors .
e. If needed, connect the other end of the Cat 5 cable to the network and turn on the power
from the power supply.
Note:
1. Do not reassemble the camera’s inner cover and hemispheric cover until after
hardware configurations are made.
2. Remember to replace desiccants every time the cover is opened.