Flex innovations FeatherLite RV-8 70cc FLS, Инструкция по эксплуатации

Страница: 33 / 96

RV-8 70cc FLS Instructions
29
IMPORTANT
The aluminum tail wheel bracket and tailwheel wire are key structural elements and act like a hinge.
It is important that these parts are not modified or replaced and that the screws mounting the
bracket to the fuselage are not omitted.
Pull/Pull System
Required for this section
Components Tools Adhesives/Building Materials
o
Fuselage Assembly
o
Rudder Servo
o
4-inch Double Servo Arm
o
Wire Crimps (4)
o
Pull-Pull Cable (2)
o
Hobby Knife with a #11
blade
o
#1 Phillips Screwdriver
o
Thin CA
⃞
1. Use a #1 Phillips screwdriver to thread a servo mounting screw into each of the pre-cut
holes in the servo mounting location on the rudder servo tray inside the fuselage.
Remove the screw and apply a small amount of thin CA to each of the holes to harden
the threads cut by the screw. Let the CA fully cure before moving forward.
⃞
2. Insert the rudder servo into the rudder tray inside the fuselage with the output shaft
towards the nose of the airplane. Mount the servo to the tray using the screws provided
with your servo.
⃞
3. Center the servo using your radio system. Install the 4-inch servo arm so that is
perpendicular to the servo case. Apply a small drop of blue thread lock onto the servo
arm screw and secure it in place. If you are using a servo arm with clamping screws, apply
a drop of blue thread lock and secure them in place.