RV-8 70cc FLS Instructions
6
instruction manual. All components must be installed correctly so that they operate correctly
both on the ground and in the air.
6.
Inspect and check operation of the model and all its components before every flight.
7.
If you are not an experienced pilot, or have not flown a high-performance model before, it is
recommended that you seek assistance from an experienced pilot in your R/C club for your
first flights. If you're not a member of a club, the Academy of Model Aeronautics (AMA) has
information about clubs in your area whose membership includes experienced pilots.
8.
Keep the propeller area clear from such items as loose clothing, jewelry, long hair, or tools, as
they can become entangled. Keep your hands and body parts away from the propeller as
injury can occur.
SPECIAL LANGUAGE DEFINITIONS
The following terms are used throughout the product literature to indicate various levels of potential
harm when operating the product.
NOTICE:
Procedures, which if not properly followed, create a possibility of physical
property damage AND a liable or no possibility of injury.
CAUTION:
Procedures, which if not properly followed, create a probability of physical
property damage AND a possibility of serious injury.
WARNING:
Procedures, which if not properly followed, create the probability of property
damage, collateral damage and serious injury OR create a high probability of
serious injury.
IMPORTANT BEFORE ASSEMBLY
Carefully unpack your aircraft and inspect the parts. Review the manual and gather the required tools
and supplies.
o
Remove all parts from their plastic bags, inventory all items and closely examine all the major
airframe components for damage. If any items are missing or you find damaged components,
do not proceed. Please contact customer support.
o
Use a covering iron with a covering sock on high heat to tighten the covering as necessary,
paying special attention to the leading edges of the flying surfaces, hinge lines and stabilizer
and wing saddle areas. Apply slight pressure over sheeted areas to thoroughly bond the
covering to the wood. Use caution around seams to prevent inadvertently pulling them loose.
o
Pro-Tip:
You can use a “Seal-It Pen” to permanently seal any sharp edges or corners of
covering that may come loose in flight.
o
Use thin CA to go over any important glue joints, such as the motor box, firewall, servo
mounting rails and any other pre-assembled joints that may see high stress during flight.
o
Gather all required components such as motor and radio equipment that will be used to
equip the airplane. Create a new radio program in your transmitter and bind this model
program to the receiver that will be used in the airplane
o
IMPORTANT NOTE:
The canopy is attached to the fuselage differently than you may have experienced with other
aircraft. To remove it, remove the two screws. Slide the canopy to the rear (DO NOT LIFT UP).
Once the canopy has been moved aft approximately 1/2-inch (12mm), lift at the rear and
continue moving the canopy to the rear as it is lifted away from the fuselage.
Содержание FeatherLite RV-8 70cc FLS
Страница 1: ...RV 8 70cc FLS ARF and ARFSV Instruction Manual...
Страница 83: ...RV 8 70cc FLS Instructions 79 INNOV A TIONS TM 35 0000 3 5 0 0 0 0 Aura...
Страница 85: ...RV 8 70cc FLS Instructions 81 RV 8 70cc FLS Camouflage Scheme ARMY GROUND EARTH HERE ARMY GROUND EARTH HERE...
Страница 86: ...RV 8 70cc FLS Instructions 82 U S ARMY...
