Flex innovations FeatherLite RV-8 70cc FLS, Инструкция по эксплуатации

Страница: 23 / 96

RV-8 70cc FLS Instructions
19
the largest hole in the aluminum bracket. The large hole is just big enough to fit the wire
through it. It may be snug, but do not drill out this hole as it is important to keep this
tolerance tight for the longevity of your tail wheel bracket. Slide the fiberglass half hinge
over the L bend side of the tail wheel wire.
⃞
3. Use a file to make two small flat spots on the inside and outside of the tail wheel wire for
the lock collar set screws
⃞
4. Finish the tail wheel bracket assembly by sliding a M3 wheel collar onto the tail wheel
axle with the flange facing the wheel location. Apply blue thread lock to a setscrew and
secure the wheel collar to the tail wheel wire. Apply a drop of light oil on the axle and
slide the tail wheel onto the axle. Install another wheel collar, with the flange facing the
tail wheel, and use blue thread lock when securing the set screw in place. Be sure the
collars are spaced so that the tailwheel spins freely.
⃞
5. Mix an adequate amount of 30-minute epoxy. Hold the rudder with the leading edge up
and apply the epoxy to the tail wheel wire hole, as well as the slot for the half hinge.
Insert the wire and half hinge fully into their holes. Use isopropyl alcohol and a paper
towel to clean up any excess epoxy. Let these parts dry for at least 1 hour before
continuing with the rudder installation.